TTG-7000 operation manual - AvionTEq
TTG-7000 operation manual - AvionTEq TTG-7000 operation manual - AvionTEq
Menu ControlFunction4 Tx Path allows setting the Tx path to Top All Ports/Bottom All Ports/Single Port. ForUAT, UAT #1 is set to B1 port and UAT #2 is set to B2 port.5 Tx Power Numeric Box allows the setting of the Transmitter power from -20 to -90dBm in 1 dB steps.6 Tx Frequency Numeric Box allows the setting of the Transmitter frequency. Individualsetting for each transmitter. Range from 962 to 1213 MHz in 0.1 MHz steps.7 Generator On/OffSoftkeyFactory SetupSignal Generator MenuFunctionSets all hardware to default setting according tohardware configuration.Generator CSignal On/Off Same as menu control item 7.Frequency Same as menu control item 6.Modulation Same as menu control item 3.PathSame as menu control item 4.Power Same as menu control item 5.PhaseNot Used.Rise/Fall Not Used.Ext. Mod Not Used.Generator ESame as Generator C.Receiver Path Same as menu control item 2.Suppression Out On/OffFuture use.OEM Select Same as menu control item 1.Phase NoiseNot used.PulsewidthNot used.TTG-7000 User’s Manual Page 14890-7000-0001 Rev E
3.1.4.2. UAT Receiver MenuFigure 3.1.4.2.1 illustrates the TTG-7000 UAT Receiver Menu. The UAT Receiver Menu allows the user toview the transmissions from an UAT system and the transmissions from the TTG-7000 test set.12Figure 3.1.4.2.1 – TTG-7000 UAT Receiver MenuMenu Control Function1 Top section of the Receiver Menu illustrates the status of reception from either theTCAS system under test or from the test set. There is a LED associated for the ATCRBSReply, DF Reply, ATCRBS Interrogation, and UF Interrogation for the TCAS System (RxGroup) and the test set (Tx Group). For UAT option, LEDs are shown in the Rx and Txgroup.2 Reception section shows the last 8 receptions. Lines in blue represent receptionsfrom the TCAS system. Lines in green represent receptions from the test set.TTG-7000 User’s Manual Page 14990-7000-0001 Rev E
- Page 97 and 98: Menu Control Function8 Latitude. Ra
- Page 99 and 100: 3.1.2.5.8. Dynamic TIS-B Definition
- Page 101 and 102: SoftkeyFunctionIdent Format Type Sa
- Page 103 and 104: Menu Control Function8 Latitude. Ra
- Page 105 and 106: 3.1.2.5.10. Dynamic ADS-R Definitio
- Page 107 and 108: SoftkeyFunctionAltitude Same as men
- Page 109 and 110: 3.1.2.5.12. TCAS Ground Station Men
- Page 111 and 112: SoftkeyFunctioncontents.TTG-7000 Us
- Page 113 and 114: SoftkeyResetF1 Pulse C1 Pulse A1 Pu
- Page 115 and 116: SoftkeyFunctionTx Channel Same as m
- Page 117 and 118: Menu Control Function10 Vertical Sp
- Page 119 and 120: SoftkeyFunctionVideo Block Number S
- Page 121 and 122: 3.1.2.6. TCAS ATE Line MenuFigure 3
- Page 123 and 124: 3.1.2.7. TCAS Chamber Mode MenuFigu
- Page 125 and 126: 3.1.2.8. Measurement MenuFigure 3.1
- Page 127 and 128: 123478956Figure 3.1.2.8.2 - Measure
- Page 129 and 130: 3.1.3. Transponder MenuFigure 3.1.3
- Page 131 and 132: Menu Control Function5 Tx Path allo
- Page 133 and 134: Menu Control Function8 Suppression
- Page 135 and 136: Menu Control Function8 Suppression
- Page 137 and 138: Menu Control Function8 Suppression
- Page 139 and 140: Menu Control Function8 Suppression
- Page 141 and 142: Menu Control Functionsteps. Power d
- Page 143 and 144: Menu Control Functionsteps. Power d
- Page 145 and 146: Menu Control Function9 Interrogatio
- Page 147: 3.1.4.1. UAT SettingsFigure 3.1.4.1
- Page 151 and 152: SoftkeyFiltered Masked MenuHighligh
- Page 153 and 154: SoftkeyFunctionAltitude Same as men
- Page 155 and 156: Menu Control Functionsaved file.9 U
- Page 157 and 158: Menu Control Function12 NIC13 Uplin
- Page 159 and 160: Figure 3.1.4.4.1.3 illustrates the
- Page 161 and 162: SoftkeyFunctionType Same as menu co
- Page 163 and 164: SoftkeyFunctionType Same as menu co
- Page 165 and 166: 5. If all devices enabled in the co
- Page 167 and 168: 10. If the scenario terminates, the
- Page 169 and 170: LatitudeLongitude-90 to 90 degrees-
- Page 171 and 172: Stop at Scenario Duration 0 to Scen
- Page 173 and 174: Identification CodeStatic (STAxxx)
- Page 175 and 176: Note: That for all intruders the lo
- Page 177 and 178: Figure 4.2 - VNC Viewer Connection
- Page 179 and 180: 5. TEST CONFIGURATIONSTTG-7000 User
- Page 181 and 182: TCAS/Hybrid Surveillance/ITP Versio
- Page 183: TCAS Coordinated RA Test Configurat
3.1.4.2. UAT Receiver MenuFigure 3.1.4.2.1 illustrates the <strong>TTG</strong>-<strong>7000</strong> UAT Receiver Menu. The UAT Receiver Menu allows the user toview the transmissions from an UAT system and the transmissions from the <strong>TTG</strong>-<strong>7000</strong> test set.12Figure 3.1.4.2.1 – <strong>TTG</strong>-<strong>7000</strong> UAT Receiver MenuMenu Control Function1 Top section of the Receiver Menu illustrates the status of reception from either theTCAS system under test or from the test set. There is a LED associated for the ATCRBSReply, DF Reply, ATCRBS Interrogation, and UF Interrogation for the TCAS System (RxGroup) and the test set (Tx Group). For UAT option, LEDs are shown in the Rx and Txgroup.2 Reception section shows the last 8 receptions. Lines in blue represent receptionsfrom the TCAS system. Lines in green represent receptions from the test set.<strong>TTG</strong>-<strong>7000</strong> User’s Manual Page 14990-<strong>7000</strong>-0001 Rev E