Service manual and spare parts list - BUKH Bremen
Service manual and spare parts list - BUKH Bremen
Service manual and spare parts list - BUKH Bremen
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
7. Procedure to adjust the shifting lever cover<br />
Manual <strong>and</strong> Spare Parts List ZF M line<br />
New bracket p/n 20.4039.02 to adjust the shifting lever cover (see picture 1).<br />
A) Before mounting the cover clean the mating surfaces <strong>and</strong> adjust the shifting fork<br />
to the neutral position.<br />
B) Apply Loctite 574 (or alternatively 518) on the cover surface <strong>and</strong> position it with<br />
the lever in neutral (see picture 2).<br />
Only for ZF 25 M, 25 MA: Push towards the bottom (see picture 3).<br />
C) Lightly tighten the four nuts.<br />
D) Adjust the cover roughly in the middle.<br />
E) Fit the adjusting bracket p/n 20.4039.02 using only one nut lightly tighten: the<br />
cover must be free to move with light hammer taps (see picture 4).<br />
If the shifting lever in neutral has been rotated from the original vertical position<br />
apply on the adjusting bracket the suitable extension section P/N 20.4039.03 (see<br />
picture 5).<br />
F) Move the lever toward the detent A without engaging the clutch <strong>and</strong> mark the<br />
position; repeat the same for the detent B. If the shifting lever has two holes<br />
refer to the inner hole (see picture 6 <strong>and</strong> 7).<br />
5<br />
6<br />
ZF 25 M, ZF 25 MA<br />
1<br />
2<br />
3<br />
4<br />
7<br />
47
Change language