Service manual and spare parts list - BUKH Bremen

5.8 Disassembling the output
shaft (66)
5.8.1 Mount support rail on a vice with
the pins pointing upwards (not on ZF 15
MIV).
5.8.2 Place output shaft (66) vertically
on the support rail with the flange side
down.
5.8.3 Remove screw (41) spacer (42)
and outer bearing race (34).
Only in models ZF 3 M - 5 M remove
also shims (68) and in model ZF 15 MA
spacer (68).
Fig. 18
41
34
36
Manual and Spare Parts List ZF M line
5.8.4 Place side of gear (65) adjacent to
shaft flange against a suitable support
(a divided flange or two brackets of suitable
section) and use pin of suitable size
to press off the output shaft.
Do not place the support neither against
the gear's (65) teeth nor against the friction
washer (43). But place it as shown
on the drawing below.
The parts removed from the upside of
the shaft are not interchangeable with the
parts removed from the flange side. Keep
separately.
5.8.5 Remove keys (67) from the output
shaft and keep in a separate place (1
key for ZF 3 M and 5 M, 2 keys for ZF 10
M, 12 M, 15 M, 15 MA, and 4 keys for
ZF 25 M, 25 MA and ZF 30 M).
42
68
65
Fig. 19
65
43