Service manual and spare parts list - BUKH Bremen

More documents

Recommendations

Info

1.2.6 ZF 15 MA 16 Manual and Spare Parts List ZF M line Transmission power input Gearbox input speed (1/min) Power diagram for Pleasure Craft Duty Based on engine power B to DIN 6270; shock factor K = 1.25 to applied, if engine has 1 cylinder K = 1.20 for 2 cylinders K = 1.15 for 3 cylinders ** Max. 120 Nm (88.5 ft lb) admissible for main travelling direction with gear lever set to «B» MODEL RATIO POWER / RPM INPUT POWER CAPACITY MAX WEIGHT BELL HSGS. «A» Pos «B»Pos kW hp kW hp kW hp kW hp RPM kg lb AND NOTES 2800 rpm 3000 rpm 3600 rpm ZF 15 MA 1.875 1.955 0.0152 0.0204 43 57 46 61 55 73 5000 13 29 SAE 4, 5, B/W, Yanmar JH 2.136 1.955 0.0131 0.0176 37 49 39 53 47 63 5000 Max input power 55 kW. 8 degrees 2.632 1.955 0.0111 0.0149 31 42 33 45 40 54 5000 Ratio 1.875 «B» Pos. max torque 120 Nm. Ratio 2.136 «B» Pos. max torque 120 Nm. «A» POS = continuous running position (normally AHEAD). «B» POS = reverse position. B/W = Borg Warner adaptor. Note = For all «M» (Mechanical) transmission reduce power capacity by the following schock factors: 1 cylinder engine ÷ 1.25, 2 cylinder engine ÷ 1.20, 3 cylinder engine ÷ 1.15.
Fig. 8 ZF 15 MA Manual and Spare Parts List ZF M line Model without mounting flange a) Clockwise rotation b) Oil dipstick and filler screw 17 mm c) M 8/12 deep, holes same on both sides d) Oil drain plug 17 mm width across flats e) Spline profile similar B 10 x 23 x 29 DIN 5464 f) Minimum lever travel g) Support for control cable h) full profile All dimensions in mm Model with mounting flange 17
Page 1: Cod. 310.01.0052f SERVICE SERVICE M
Page 4 and 5: Table of contents 1. Description 1.
Page 6 and 7: 1.2.1 ZF 3 M 6 Manual and Spare Par
Page 8 and 9: 1.2.2 ZF 5 M 8 Manual and Spare Par
Page 10 and 11: 1.2.3 ZF 10 M 10 Manual and Spare P
Page 18 and 19: 1.2.7 ZF 15 MIV 18 Manual and Spare
Page 22 and 23: 1.2.9 ZF 25 MA 22 Manual and Spare
Page 24 and 25: 1.2.10 Accessories 24 Manual and Sp
Page 26 and 27: 1.2.10 Accessories 26 Manual and Sp
Page 28 and 29: 1.2.12 Gearboxes and accessories 28
Page 30 and 31: 1.6 Shaft bearings Both the input a
Page 32 and 33: 2.10 Cooling unit The arrangement o
Page 34 and 35: 34 Manual and Spare Parts List ZF M
Page 36 and 37: 5.8 Disassembling the output shaft
Page 38 and 39: 6. Reassembly Note: fold out illust
Page 40 and 41: 6.7 Pre-assembling the bearing shie
Page 42 and 43: 6.10.10 Attach shims (53,54,55, 56)
Page 44 and 45: 6.13.3 Measure dimension «c» on c
Page 46 and 47: 6.14 Mounting the actuating lever c
Page 48 and 49: 48 B A 8 9 10 11 Manual and Spare P
Page 50 and 51: 9. Spare Parts List 50 Manual and S
Page 52 and 53: ZF 3 M - ZF 5 M ZF 10 M HBW 10/ZF 1
Page 58 and 59: Item No 58 Manual and Spare Parts L
Page 60 and 61: SEAL + CLUTCH PACK KITS 60 Manual a
Page 62 and 63: BEARING KITS (ALL VERSIONS) 62 Manu
Page 64 and 65: 64 Manual and Spare Parts List ZF M
Page 66:
66 Manual and Spare Parts List ZF M
show all

Service manual and spare parts list - BUKH Bremen

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?