IR-WMR - Solid Signal

PRELIMINARY DATA SHEETFor Receiving and RoutingInfrared Commands fromany Remote ControlPLASMA-PROOF WALL MOUNT IR RECEIVERIR-WMR

IR-WMRPLASMA-PROOF WALL MOUNT IR RECEIVERFEATURES• Plasma proof design• Rejects interference from flat panel displays, CFL lighting or indirect sunlight• Works with practically all remotes• Extended receiving range• Red talkback LED indicates when A/V system is on• Blue talkback LED confirms reception of IR signalsINSTALLATION FRIENDLY DESIGN:• Snap and lock connector secures wire in place without the use of ascrewdriver• Includes Decora® faceplateSPECIFICATIONS• IR system: Works with practically all brands of IR remote controls• IR receiving (varies by brand of remote control):18’-30’ From 18’ 30 degreesoff-axisWIRING REQUIREMENTS:• Category 5 or better• Home runs requiredMOUNTING:• Single gang electrical box at least 2-3/4” deepDIMENSIONS:• 1-5/8” wide x 2-5/8” high x 2-3/4” deep• Depth behind faceplate: 2-3/4”WARRANTY:• 2 year limitedJOBSITE SYSTEMS12331 SW 130 STREETMIAMI, FL 33186P 866.4JB.SITE (866.452.7483)F 305.238.0185WWW.JOBSITESYSTEMS.COMPLASMA-PROOF WALL MOUNT IR RECEIVERIR-WMR

PREPARING FOR INSTALLATION:If you are installing the IR-WMR into an existing wall, take time to consider anypossible obstructions which may be hidden inside the wall, such as wood ormetal studs, electrical, telephone or other types of wiring, plumbing, AC orheating conduit. You should avoid locating the IR-WMR near potential sources ofelectrical or optical noise, such as light dimmers or low-voltage lights.INSTALLATION:1. Identify the IR Receiver wire. Label the wire for future reference.2. Strip 1/4" of insulation from the end of each CAT5 wire.3. Locate the Snap and lock connector and remove it if it is plugged in.4. Use a small flathead screwdriver or your thumb to raise the locking tabs,exposing the holes on the connector.5. Insert each wire into the appropriate hole and snap down the locking tabs.6. Insert the smooth side of the connector plug into the smooth side of theIR-WMR socket.7. Install the IR-WMR into the device ring.8. Fasten the cover plate.IR-WMR INSTALLATION DIAGRAMIR-WMRJobSiteIR-E1EmitterStereo Receiver12V DC Power Supply(Not Supplied) plugged intothe Switched Outlet12V DC Power SupplyPlugged into anUnswitched AC OutletIR-CB-2JOBSITE SYSTEMS12331 SW 130 STREETMIAMI, FL 33186P 866.4JB.SITE (866.452.7483)F 305.238.0185WWW.JOBSITESYSTEMS.COM©2004 Niles Audio Corporation. JobSite,Pure Custom and Niles are registeredtrademarks of Niles Audio Corporationand the JobSite Logo is a trademark ofNiles Audio Corporation. JSIRWMRPDFSpecifications subject to change without notice.PLASMA-PROOF WALL MOUNT IR RECEIVERIR-WMR