Power Grid Analysis in VLSI Designs - SERC

More documents

Recommendations

Info

Power SwitchFigure 5.2 Layout of 1M gate with switch networkFigure 5.3 Current Glitch and Voltage Ramp at arbitrary switch outputA typical PG network with Power Switches can be represented as shown in Figure 5.4. Some ofthe characteristics of this network are: [87]• 2 domains – one golden domain and non-gated power supply, second multiple virtualdomains and switched power supply.• All virtual domains are unconnected within. They are connected to golden domainthrough switch network.92
• Switch network consists of one or more different kind of switches for a given domain.• Switch network across virtual power domains are not shared.• Random logic is connected to golden domain as well as all virtual domains.• Control logic enables any one or more virtual domains to turn on/off any time.• Further, any switch network consists of parallel network or sequential network orcombination of both. Parallel configuration allows all switches to turn onsimultaneously whereas sequential configuration allows each switch to turn on one byone after some delay.Switch Control LogicOffchip Power supplyNonGatedVDDSwitchSWVirtual PowerPower NetworkNetworkNetworkLogicNetworkZOOMLogicNetworkVDD SW1SW VDD SW2SW VDDSW3SWN SwitchesParallel ConfigurationVDD SW1SW VDD SW2SW VDDSW3SWD1 D1 D1N SwitchesSequential ConfigurationFigure 5.4 Typical PG network with Power SwitchesWhen the power supply is ‘off’ and virtual network is disconnected, the current that passesthrough is leakage current. If leakage current of the virtual logic is significantly higher than thatof switch network leakage, leakage current improvement happens. When the switches areturned on i.e. when the power supply connects to virtual power network, the loads in virtual93
Page 1:
Power Grid Analysis in VLSI Designs
Page 6 and 7:
4.4.1 Timing Information Generation
Page 8 and 9:
Figure 3 1GHz, Peak: 838.2 uW......
Page 11 and 12:
AbstractPower has become an importa
Page 13 and 14:
1 Introduction1.1 MotivationVLSI in
Page 15 and 16:
Further, Figure 1.3 shows that ther
Page 17 and 18:
proposed in a few papers. In this t
Page 19 and 20:
• Degradation in switching speeds
Page 21 and 22:
Second, today’s design has huge P
Page 23 and 24:
Figure 1.6 Total power break up int
Page 25 and 26:
CMOSDieAcronym for Complimentary Me
Page 27 and 28:
2 Toggle Activity Estimation2.1 Ove
Page 29 and 30:
For large T, D(x) becomes time inva
Page 31 and 32:
done hierarchically or there is reu
Page 33 and 34:
A Sample SDC file with above comman
Page 35 and 36:
Some of the care needs to be taken
Page 37 and 38:
Figure 2.5 Timing Arcs in extracted
Page 39 and 40:
3 Power Estimation3.1 OverviewAccur
Page 41 and 42: In this work, above power component
Page 43 and 44: on the required accuracy, different
Page 45 and 46: Based on power sensitivity and tool
Page 47 and 48: with SPICE. Power Mill is dynamic s
Page 49 and 50: DREPGENDREPFILE+ DATAGENFUNCTDLRAND
Page 51 and 52: 3.4.3 Interconnect setupAll the cir
Page 53 and 54: DesignNameIN OUT Flops Boolean(gate
Page 55 and 56: Design TFC + Power Compiler Runtime
Page 57 and 58: Design Name CLK Power Total Power %
Page 59 and 60: DesignNamePowerCompilerProposedAppr
Page 61 and 62: We can approximate the average powe
Page 63 and 64: 4 Power Supply Noise Analysis4.1 Ov
Page 65 and 66: to be absolutely in complete alignm
Page 67 and 68: In this work, we have maintained te
Page 69 and 70: Figure 4.6 Load vs. peak power for
Page 71 and 72: 3. The temporal correlation between
Page 73 and 74: Each such armRepresents resistance
Page 75 and 76: Characterized data was transformed
Page 77 and 78: Do timing analysis and based on inp
Page 79 and 80: of any node. Alternatively frequenc
Page 81 and 82: Cell Char @ fix frequency(10MHz in
Page 83 and 84: We executed the flow as explained i
Page 85 and 86: Circuit%Drop inaverage activity%Dro
Page 87: 4.6 SummaryWe proposed novel PG net
Page 90 and 91: network but causing huge dynamic IR
Page 94 and 95: power network start getting charged
Page 96 and 97: Note that the 1 stcharacterization
Page 98 and 99: • Maximum current surge that will
Page 100 and 101: gates in the virtual network or mor
Page 102 and 103: Vdesired (mV)Actual#SwitchesSwitche
Page 104 and 105: 5.4 SummaryThere are various techni
Page 106 and 107: 5. Power Up analysis for MTCMOS bas
Page 108 and 109: 108
Page 110 and 111: 21. F.N. Najm, R.Burch, P. Yang, an
Page 112 and 113: 62. H. Mehta, R.M.Owens, M.J.Irwin,
Page 114 and 115: 114
Page 116 and 117: Appendix B Sample SPEF Format*SPEF
Page 118 and 119: Appendix C Power Waveforms Analysis
Page 120 and 121: Appendix E Waveform transformation
show all

Power Grid Analysis in VLSI Designs - SERC

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?