Power Grid Analysis in VLSI Designs - SERC

More documents

Recommendations

Info

Vdesired (mV)Actual#SwitchesSwitches byAlgorithmCurrentSurge (mA)Current Surgeafter #switches20 380 403 950 12369 760 771 881 114271 1560 1554 749 100583 2340 2328 467 97869 2964 2971 266 811170 4368 4308 24 43Table 5.1 Switch Prediction by proposed algorithm#SwitchesSimulatedVoltage (mV)Voltage byAlgorithmSurgeCurrentSurge Currentafter switch #(mA)%Error involtages780 63 70.54 892 101 111560 280 273.53 784 94 -0.22340 587 589.26 546 78 0.383120 926 927.7 263 64 0.18Table 5.2 Voltage Prediction102
No. of switches Simulation Time (in days) Algorithm Runtime (in mts)780 ~1.5 < 11560 ~4 < 12340 ~5 < 12940 ~6 < 1Table 5.3 Power Up analysis - Runtime Comparison1400Voltage in mV120010008006004002000TimePredicted SPICE@node1 SPICE@node2Figure 5.9 Voltage Ramp up over Time for various nodes1000Current in mA8006004002000TimePredictedSPICEFigure 5.10 Current comparison over time103
Page 1:
Power Grid Analysis in VLSI Designs
Page 6 and 7:
4.4.1 Timing Information Generation
Page 8 and 9:
Figure 3 1GHz, Peak: 838.2 uW......
Page 11 and 12:
AbstractPower has become an importa
Page 13 and 14:
1 Introduction1.1 MotivationVLSI in
Page 15 and 16:
Further, Figure 1.3 shows that ther
Page 17 and 18:
proposed in a few papers. In this t
Page 19 and 20:
• Degradation in switching speeds
Page 21 and 22:
Second, today’s design has huge P
Page 23 and 24:
Figure 1.6 Total power break up int
Page 25 and 26:
CMOSDieAcronym for Complimentary Me
Page 27 and 28:
2 Toggle Activity Estimation2.1 Ove
Page 29 and 30:
For large T, D(x) becomes time inva
Page 31 and 32:
done hierarchically or there is reu
Page 33 and 34:
A Sample SDC file with above comman
Page 35 and 36:
Some of the care needs to be taken
Page 37 and 38:
Figure 2.5 Timing Arcs in extracted
Page 39 and 40:
3 Power Estimation3.1 OverviewAccur
Page 41 and 42:
In this work, above power component
Page 43 and 44:
on the required accuracy, different
Page 45 and 46:
Based on power sensitivity and tool
Page 47 and 48:
with SPICE. Power Mill is dynamic s
Page 49 and 50:
DREPGENDREPFILE+ DATAGENFUNCTDLRAND
Page 51 and 52: 3.4.3 Interconnect setupAll the cir
Page 53 and 54: DesignNameIN OUT Flops Boolean(gate
Page 55 and 56: Design TFC + Power Compiler Runtime
Page 57 and 58: Design Name CLK Power Total Power %
Page 59 and 60: DesignNamePowerCompilerProposedAppr
Page 61 and 62: We can approximate the average powe
Page 63 and 64: 4 Power Supply Noise Analysis4.1 Ov
Page 65 and 66: to be absolutely in complete alignm
Page 67 and 68: In this work, we have maintained te
Page 69 and 70: Figure 4.6 Load vs. peak power for
Page 71 and 72: 3. The temporal correlation between
Page 73 and 74: Each such armRepresents resistance
Page 75 and 76: Characterized data was transformed
Page 77 and 78: Do timing analysis and based on inp
Page 79 and 80: of any node. Alternatively frequenc
Page 81 and 82: Cell Char @ fix frequency(10MHz in
Page 83 and 84: We executed the flow as explained i
Page 85 and 86: Circuit%Drop inaverage activity%Dro
Page 87: 4.6 SummaryWe proposed novel PG net
Page 90 and 91: network but causing huge dynamic IR
Page 92 and 93: Power SwitchFigure 5.2 Layout of 1M
Page 94 and 95: power network start getting charged
Page 96 and 97: Note that the 1 stcharacterization
Page 98 and 99: • Maximum current surge that will
Page 100 and 101: gates in the virtual network or mor
Page 104 and 105: 5.4 SummaryThere are various techni
Page 106 and 107: 5. Power Up analysis for MTCMOS bas
Page 108 and 109: 108
Page 110 and 111: 21. F.N. Najm, R.Burch, P. Yang, an
Page 112 and 113: 62. H. Mehta, R.M.Owens, M.J.Irwin,
Page 114 and 115: 114
Page 116 and 117: Appendix B Sample SPEF Format*SPEF
Page 118 and 119: Appendix C Power Waveforms Analysis
Page 120 and 121: Appendix E Waveform transformation
show all

Power Grid Analysis in VLSI Designs - SERC

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?