XPO Portable Oxygen Concentrator - Invacare

More documents

Recommendations

Info

SECTION 1—IMPORTANT SAFEGUARDSRadio Frequency InterferenceThis equipment has been tested and found to comply with EMC limits specified by IEC/EN 60601‐1‐2. These limits are designed to provide a reasonable protection againstelectromagnetic interference in a typical medical installation.Other devices may experience interference from even the low levels of electromagneticemissions permitted by the above standards. To determine if the emissions from the XPO 2are causing the interference, turn the XPO 2 Off. If the interference with the other device(s)stops, then the XPO 2 is causing the interference. In such rare cases, interference may bereduced or corrected by one of the following measures:• Reposition, relocate, or increase the separation between the equipment.• Connect the equipment into an outlet on a circuit different from that to which theother device(s) is connected.XPO2 8 Part No 1150748
SECTION 2—COMPONENTREPLACEMENTSECTION 2—COMPONENT REPLACEMENTCAUTIONEnsure not to damage ribbon cable when removing or installing front cover.DO NOT use Methyl Ethyl Ketone (MEK). This will damage the plastic.Replacing the Gross Particle Filter or Filter CoverNOTE: For this procedure, refer toFIGURE 2.1.LMagnetCoverNOTE: The gross particle filter should becleaned or replaced according to the PreventiveMaintenance Record on page 18.1. Lift filter cover slightly and pull downto remove tabs from the grooves.2. Lift out the filter from the filter cover.3. Use a vacuum cleaner or wash with amild liquid dish detergent (such asDawn ) and water. Rinse thoroughly.4. Thoroughly dry the filter and inspectfor fraying, crumbling, tears and holes.5. Replace filter cover and/or filter.GroovesCoverTabsFilterCoverMagnetFilter6. Reinstall the filter cover by placing thetabs in the slots and engaging themagnet.NOTE: Use only Invacare gross particle filter.FIGURE 2.1 Replacing the Gross ParticleFilter or Filter CoverAccessing XPO 2 WARNINGWhen accessing the XPO 2 remember that battery power is still being applied to theinternal (PCB) printed circuit board. Care MUST be taken to minimize contact with thePCB. DO NOT use any kind of tool (screwdriver, pliers, etc.) when working on theinternal structure, otherwise, injury and/or damage may occur. Battery power remains onthe PCB as long as the battery connection is made to the PCB.NOTE: For this procedure, refer to FIGURE 2.2 and FIGURE 2.3 on page 10.Part No 1150748 9 XPO2
Page 1 and 2: Service ManualXPO 2Portable OxygenC
Page 3 and 4: TABLE OF CONTENTSTABLE OF CONTENTSS
Page 5 and 6: TYPICAL PRODUCT PARAMETERSTYPICAL P
Page 7: SECTION 1—IMPORTANTSAFEGUARDSSECT
Page 11 and 12: SECTION 2—COMPONENT REPLACEMENT4.
Page 13 and 14: SECTION 2—COMPONENT REPLACEMENTNO
Page 15 and 16: SECTION 4—TROUBLESHOOTING AND MAI
Page 17 and 18: SECTION 4—TROUBLESHOOTING AND MAI
Page 19 and 20: Function Test1. Connect XPO 2 to AC

XPO Portable Oxygen Concentrator - Invacare

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?