Conversion to 16-inch tyres and 71/2 J _16 H 2 ET 40 ... - w-124.info

3.1 If excessive PVC underbody protection hasbeen applied, grind off excess before folding backthe edge of the fender.3.2 Using a hot air gun carefully heat up outeredges of fender to a maximum of 70° - 80°C.NoteDo not overheat paint whilst applying heat(max. 80°C).3.3 In the marked area (A), the edge of the fenderis flattened down as far as the inside of the fender inseveral stages.A plastic hammer must be used to avoid damagingthe paint.NoteRectify any damage to paint or underbody protection.3.4 Treat wheel arch again with underbodyprotection. Spray the folded back fender edges withbody cavity preserver.D. Fitting the special wheelsCopyright DaimlerChrysler AG 08.12.2004 CD-Ausgabe G/05/02 Will not be recorded by Modification services Page 6