User Manual - Polaris S.p.A.

More documents

Recommendations

Info

Adjustment instructions4.11.2004 Rev. 1.16.3 Changing the light bulbTo change the light bulb perform the following steps (the voltage of the light bulb isshown on the adhesive label):• Switch off the appliance and disconnect the power cord;• Open the appliance door;• Remove the protective glass shield from the light;• Unscrew the light bulb located in the instrument panel and replace it with an identicalcomponent of the same voltage;• Refit the glass shield.6.4 Attaching and detaching the grille support guideCarry out the following steps to attach the grille support guides correctly:Push the guide downwards (2) and then inwards (3) in the chosen position of the rack.Pic. 6.4Perform the operation in reverse order to detach the guide.22
Troubleshooting4.11.2004 Rev. 1.17. TroubleshootingIn the event of malfunction, check the list below to see if it is possible to restore the applianceto working condition without needing to call the technical support service. Forfurther information, please contact your nearest technical support centre.TROUBLE POSSIBLE CAUSE REMEDYSENSOR(S) FAILURECOMPRESSOR WILLNOT RESTARTCOMPRESSOR SEL-DOM STOPSFROSTED COMPRES-SOR SHELLNOISY APPLIANCEOVERFLOWING OFSELF-EVAPORATINGCONDENSATE TRAYSensor disconnectedSensor damagedElectrical equipment of the compressor(relay, motor protection and condenser) isfaulty.Compressor has a winding open or shorted,or there is an earth (ground) faultRoom temperature is too highRefrigerated cabinet condenser is dirtyLow refrigerant chargeDoor gaskets do not ensure proper sealFrost build-up on the evaporatorExcess refrigerant chargeFrost build-up on the evaporatorEvaporator motor fan(s) damagedLoose screwsVibrating pipesHot or high-water content foodstuffs arebeing introduced into the appliance too oftenDoors and/or drawers are opened too oftenConnect sensor to the thermostat againCall an authorised technical support centre tohave it replacedCall an authorised technical support centre tohave the concerned component replacedCall an authorised technical support centre tohave the compressor replacedEnsure proper ventilation to the roomCheck it on a regular basis and clean it thoroughlyCall an authorised technical support centre tofind and repair any leaks and to recharge thecompressor with refrigerant.Call an authorised technical support centre toperform the necessary replacementDo not place hot or high water content foodstuffsinto the appliance and, if needed, perform a manualdefrost cycle.Call an authorised technical support centreDo not place hot or high water content foodstuffsinto the appliance and, if needed, perform a manualdefrost cycle.Call an authorised technical support centre toperform the necessary replacementCheck that all screws are tightened and tightenthem if needed.Check that they are well fixed and, if needed,space adjoining pipes out so that they do not collide.Do not introduce hot or high water content foodstuffsinto the appliance.Pay attention to the conditions of use of your appliance.23
Page 1: FREEZERSA Plus serieBTBTVTYPE: 70,
Page 4 and 5: 4.11.2004 Rev. 1.1
Page 6 and 7: 4.11.2004 Rev.5.7.3 Suggestions ...
Page 8 and 9: General information4.11.2004 Rev. 1
Page 10 and 11: Safety4.11.2004 Rev. 1.12.2.1 Insta
Page 12 and 13: Functional description4.11.2004 Rev
Page 14 and 15: Operating instructions4.11.2004 Rev
Page 16 and 17: Operating instructions4.11.2004 Rev
Page 18 and 19: Installation4.11.2004 Rev. 1.15.3 U
Page 20 and 21: Adjustment instructions4.11.2004 Re
Page 30 and 31: Troubleshooting4.11.2004 Rev. 1.124
Page 32 and 33: Spare parts4.11.2004 Rev. 1.126
Page 44 and 45: Technical specifications4.11.2004 R
Page 46 and 47: Wiring diagram BT, BTV
Page 56 and 57: DICHIARAZIONE DI CONFORMITA’DECLA
Page 60: M_SPABT_uen11.pdf

User Manual - Polaris S.p.A.

Create successful ePaper yourself

Delete template?

Save as template?