RFID Systems - Allied Automation, Inc.

Barcode Imaging SystemsAdditional InformationDecode ZonesFixed-Mount Imagers MAC333Imager7.5 mil Data Matrix4.2 mil Code 3920.8 mil Data Matrix15.8 mil Data MatrixNear Field OptimalFocal Point 4.6”5.8 mil Code 397.5 mil Code 12820 mil PDF 417Far Field OptimalFocal Point 10.5”Maxicode12.5 mil UPC14.2 mil Code 12820.8 mil Code 394.0in./10.2cm2.0in./5.1cm0.0in./0.0cm2.0in./5.1cm4.0in./10.2cm0.0in./0.0cm 4.0in./10.2cm 8.0in./20.3cm 12.0in./30.5cm 16.0in./40.6cm 20.0in./50.8cmNear Field Decode Zone Neutral Decode ZoneFar Field Decode ZoneMAC333 Serial Port SettingsThe factory default serial port for the MAC333 is 57600, 8-bits, no parity, 1 stop bit. If there isany problem with communication, the following scan codes will reset the settings to facilitatecommunication via the serial port.Syntax is [baudrate], [databits], [parity], [stopbits]. Factory default is 57600, 8, none, 157600 8 none 1The unit is shipped from the factory in the continuous scan mode so that these codes may beread. If your unit is not in this mode and you cannot communicate with the serial interface toprompt a reading, it may be necessary to externally trigger the unit in order to gain control of theserial interface using the scan codes above.118Pepperl+Fuchs®Inc. • 1600 Enterprise Parkway • Twinsburg, Ohio 44087-2245 • www.am.pepperl-fuchs.comTelephone (330) 486-0001 • FAX (330) 405-4710 • E-Mail: sales@us.pepperl-fuchs.com