S3.25 Leg Press Station - Precor

S3.25 Leg Press Option Assembly Instructions5. Route the CableAs you route the Cable through the pulleys on the LegPress Option, wrench tighten the fasteners on eachpulley as you go. Make sure that the Cable slides freelyalong the pulley (and beneath the cable retainer). Makesure that you are using the correct Cable before youtighten the fasteners.A. Attach the barrel end of Cable 40538-101 to theSeat Frame usingone 4-inch boltone washerone locknutWrench tighten so that the barrel end of the Cablerotates freely.B. Loosen all the fasteners that attach the pulleys tothe Seat Frame.C. Push the Pivot Arm forward so that the pulleys areeasily accessible.D. Route the Cable around the pulley inside the PivotArm Cover that is on the same side as the barrelend of the Cable (see illustration). The Cableshould slide along the pulley beneath the cableretainer. Wrench tighten this pulley’s fasteners.E. You may need to slide the bolt out of the Pivot ArmCover to wrap the Cable around the pulley.F. Continue to route the Cable around the pulleys asshown in the illustration. Make sure that the Cableslides freely along the pulleys (and beneath thecable retainers) before you wrench tighten theirfasteners.G. Wrap the Cable around the 4½-inch pulley (andbeneath its cable retainer) that is attached to theCross Brace. Wrench tighten.PivotArmPush the PivotArm forward1 - 4" bolt1 - washer1 - locknutCALoosen the pulleyB fastenersNote: The Seat Pad is not shown.Pivot ArmDEFSeat FrameCable 40538-1011 2 3 4 5 6GWrap the Cable around the4½" pulley attached to theCross BraceStep 5. Route the Cablepage 12