3M 6041 Adhesive Remover MSDS - Brock White
3M 6041 Adhesive Remover MSDS - Brock White 3M 6041 Adhesive Remover MSDS - Brock White
MATERIAL SAFETY DATA SHEET 3M(TM) Adhesive Remover 6040/6041 (Aerosol) 03/22/11AldehydesHydrocarbonsCarbon monoxideCarbon dioxideKetonesDuring CombustionDuring CombustionDuring CombustionDuring CombustionNot SpecifiedSECTION 11: TOXICOLOGICAL INFORMATIONPlease contact the address listed on the first page of the MSDS for Toxicological Information on this material and/or itscomponents.SECTION 12: ECOLOGICAL INFORMATIONECOTOXICOLOGICAL INFORMATIONNot determined.CHEMICAL FATE INFORMATIONNot determined.SECTION 13: DISPOSAL CONSIDERATIONSWaste Disposal Method: Vent cylinder or pressurized container in an operating exhaust hood or remote area.A qualified person should adjust the release rate so gas concentration in ducts is less than 20% of the lower explosive limit (LEL).The LEL is the lowest concentration that can propagate (spread) a flame. A qualified person should adjust the release rate so gasconcentration in ducts is less than 20% of the lower explosive limit (LEL). The LEL is the lowest concentration that can propagate(spread) a flame. Incinerate in a permitted hazardous waste incinerator. For quantities
MATERIAL SAFETY DATA SHEET <strong>3M</strong>(TM) <strong>Adhesive</strong> <strong>Remover</strong> 6040/<strong>6041</strong> (Aerosol) 03/22/11AldehydesHydrocarbonsCarbon monoxideCarbon dioxideKetonesDuring CombustionDuring CombustionDuring CombustionDuring CombustionNot SpecifiedSECTION 11: TOXICOLOGICAL INFORMATIONPlease contact the address listed on the first page of the <strong>MSDS</strong> for Toxicological Information on this material and/or itscomponents.SECTION 12: ECOLOGICAL INFORMATIONECOTOXICOLOGICAL INFORMATIONNot determined.CHEMICAL FATE INFORMATIONNot determined.SECTION 13: DISPOSAL CONSIDERATIONSWaste Disposal Method: Vent cylinder or pressurized container in an operating exhaust hood or remote area.A qualified person should adjust the release rate so gas concentration in ducts is less than 20% of the lower explosive limit (LEL).The LEL is the lowest concentration that can propagate (spread) a flame. A qualified person should adjust the release rate so gasconcentration in ducts is less than 20% of the lower explosive limit (LEL). The LEL is the lowest concentration that can propagate(spread) a flame. Incinerate in a permitted hazardous waste incinerator. For quantities
Change language