08 YZF-R6

• The switch installed to the STD machine may be used as is. (See diagram 2.)• Map select switches Map 1 and Map 2 of the YMS “Comp. FUEL.”CAUTION:When switching to Map 1 or Map 2 using “Map Select” while riding, check that properriding is possible even when using either map.(Diagram 2)Pit roadlimiterONOFFNot usedMap selectLo → Map 1Hi → Map 2Pit roadlimiterON ONPUSH=OFF*Use 5FL-83976-70SWITCH ASSYsupplied in thispackage as a mainswitch.Engine stopswitchStarterswitch• The ignition cut switch function can be used by combining the harness and kit ECU.1 To use the STD switch (left side) to function as the ignition cut switch, connect the wiresub-lead that was packaged with this set to the terminal that is normally connected to theleft side horn. (See diagram 3.) However, if the resistor assembly that was packaged withthe set is not installed, there is the possibility that the ignition cut switch will operateincorrectly in rainy weather. The resistor assembly is installed to the 2-pin black couplerat the tail. (See diagram 4.)CAUTION:Do not bend the resistor assembly. It will cease to function if it is bent.2Install the switch to the 2-pin black coupler underneath the fuel tank. Turning the switchON cuts the ignition.(Diagram 3) 5(Diagram 4) 6– 26 –