08 YZF-R6

Transmission AssemblyThe seal side should face outward (one sideseal bearing) and press in the bearing cup allthe way into the case until it touches bottom.Points to be careful of the oil seal assemblyThe convex part on the oil seal should beput into the case groove vertically so thatthe oil seal does not fall over and is tightlyfit into the bearing cup of the bearing.(Apply grease to the lip.)Apply molybdenum oil to inside of diameter.After assembly, it should rotate smoothly.Apply molybdenum oil to the inside diameterand end. After assembly, it should rotatesmoothly.Apply molybdenum oil to teeth of spline.After assembly, it should slide smoothly.Matching markMatching markWasherWasherNOTE:• Always use a new circlip.• Do not mistake the washer and circlip directions.(See drawing below.)CirclipShaftWasherGearShaftEdgePortion REdgePortion RPosition the abutment joint of the circlipright between the splines.Detail of installation of washerMatching markMatching markWasherRotate washer so that its teeth meet axlesplineteeth on the axle, and then lock withwasher’s claw.Assemble washer with putting togethertheir matching mark.Circlip(Directionnot applicable)ShaftDetail of installation of circlipWasherGearWasherPosition the abutment joint of thecirclip right between the splines.EdgePortion RShaftDetail of installation of washerDetail of installation of circlip– 21 –