Piper J-3 Cub Power 46 ARF+ Manual - Hangar 9
Piper J-3 Cub Power 46 ARF+ Manual - Hangar 9
Piper J-3 Cub Power 46 ARF+ Manual - Hangar 9
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Section 7: Installing the Stabilizer Step 8Attach the small brass fitting to the fin and stabilizerusing 2-56 x 1/2" screws, #2 washers and 2-56 nuts.Fittings are placed on both sides of the rudder andthe top and bottom of the stabilizer. Step 10Cut the cable into four equal pieces. Prepare one cable bysliding the cable through a crimp, through the cable end,then back through the crimp twice. Pull the excess cabletight and use a crimping tool to complete the job. Repeatfor all four of the ends. Step 9Slide a clevis retainer onto a clevis. Thread a cable endinto the clevis. Prepare four of these connectors.27