Piper J-3 Cub Power 46 ARF+ Manual - Hangar 9

Section 7: Installing the Stabilizer Step 2Attach a control horn to one of the elevator clevises. Linethe holes in the control horn with the hinge line and markthe location for the mounting crews onto the elevator. Step 4Repeat Steps 2 and 3 for the remaining elevatorcontrol horn. Step 5Attach the elevator pushrod to the servo arm of theelevator servo using a pushrod wire keeper. Step 6Bend each of the fittings (small and large) to about a45-degree angle. Step 3Drill the holes using a 3/32" drill bit. Use thin CA toharden the holes. Mount the control horn using the hornbackplate and three 2mm x 12mm screws. Step 7Attach the large brass fittings at the bottom rear of thefuselage using the #2 x 1/2" sheet metal screw.26