Piper J-3 Cub Power 46 ARF+ Manual - Hangar 9

More documents

Recommendations

Info

Section 1: Hinge Installation Step 11Cut a groove from the hole to the bottom of the rudder toallow clearance for the tail gear bearing. Step 13Cut a slot in the end of the fuselage to accept the tailgear bearing. Step 12Apply a thin layer of lubricant where the bearing willride in the rudder. Use 30-minute epoxy to glue the wireinto the rudder. Step 14Install three hinges into the rudder. Test fit the rudderto the fuselage, sliding the hinges and tail wheel bracketinto position. Step 15Use 30-minute epoxy to glue the tail gear bearing into thefuselage. Use thin CA for the hinges.10
Section 2: Motor and Cowling InstallationRequired Parts• Fuselage• Propeller• Propeller adapter • Cowling• #2 x 3/8" sheet metal screw (4)Required Tools and Adhesives• Phillips screwdriver (small)• Drill • Drill bit: 1/16", 5/64"• Soldering iron• Solder• Electronic speed control w/connectors Step 2Tin the ends of the wires on your speed control by usingthe iron to heat the bare wires. It is always a good idea toapply the iron to one sire of the wire and feed the solderfrom the opposite side to draw the solder into the wire.Note: Use a good quality solder and flux whensoldering electronic components. Check withan electronic store to purchase the appropriatecomponents for soldering if you don't havethese on hand.Important: Always make sure that what isunder your soldering iron is of no great value.Solder that drips can easily damage a surface.It is suggested to have an inexpensive piece ofplywood under your soldering area to preventdamage from dripped solder. Step 1Locate the connectors for your motor. Use pliers to holdthe connector. Heat the connector with the soldering ironand feed a small amount of solder into the connector. Step 3While the wire on the speed control is still warm, heat theconnector with the soldering iron. Slide the wire from thespeed control into the connector and leave it for a secondto make sure the solder has fully heated. Remove thesoldering iron and allow the wire/connector to cool beforemoving anything. After a minute or two, give the connectora light pull to make sure it is secure.Note: A drop of flux will make the solder"stick" better than just using the solder alone.11
Page 1 and 2: Piper J-3 CubWith Power 46Assembly
Page 3 and 4: Contents of KitCAGEDLarge Parts:A.
Page 5 and 6: Warranty PeriodExclusive Warranty-
Page 9: Section 1: Hinge Installation Step
Page 13 and 14: Section 2: Motor and Cowling Instal
Page 16 and 17: Section 3: Servo Installation (Aile
Page 18 and 19: Section 3: Servo Installation (Aile
Page 20 and 21: Section 4: Servo Installation (Fuse
Page 22 and 23: Section 4: Servo Installation (Fuse
Page 24 and 25: Section 6: Landing Gear Installatio
Page 26 and 27: Section 7: Installing the Stabilize
Page 28 and 29: Section 7: Installing the Stabilize
Page 30 and 31: Section 8: Wing Installation Step
Page 32 and 33: Recommended CGAn important part of
Page 34 and 35: 2007 Official AMANational Model Air
Page 36: 9892.2© 2007 Horizon Hobby, Inc.41

Piper J-3 Cub Power 46 ARF+ Manual - Hangar 9

Create successful ePaper yourself

Delete template?

Save as template?