INVITATION TO APPLY FOR ELIGIBILITY AND TO BID - Clark.com.ph

6.2 Communications function and design of ECF’s internal and externalphones and data connectivity systems6.3 Hook-ups for energy monitoring and control systems6.4 Domestic water and sanitary systems3.4 The Work to be done shall consist of the design and construction, complete in all details, of theworks at the subject premises, and all work and materials incidental to the Work unless expresslystated to be done by others.3.5 All work shall be done in accordance with the governing Codes and Regulations and with theseSpecifications, except where same shall conflict with existing Codes, etc., in which the latter shallthen govern.3.6 The requirements in regard to materials and workmanship specify the required standards for thefurnishing of all labor, materials, tools, appliances and equipment necessary for the completeinstallation of the work specified herein and indicated on the drawings. These specifications areintended to provide a broad outline of the required installation, but not intended to include alldetails of design and construction.3.7 The Designer-Builder shall adopt his proprietary technique to guarantee the safety andperformance of the system in accordance with the concepts and criteria set by thesespecifications. The Designer-Builder must be experienced in the works involved.3.8 No consideration will be granted for any alleged misunderstanding on the quality of materials tobe furnished or work to be done, it being understood that the submission of a proposal is anAgreement to all items and conditions referred to herein. If specified materials are not locallyavailable, the Designer-Builder must immediately place an order as soon as the project isawarded to him. Any exceptions, omissions or substitutions shall be presented in writing with theDesigner-Builder’s proposal.3.9 The Designer-Builder, before commencing work, shall examine the proposed location of theproject and all adjoining areas on which this work is in any way dependent for perfectworkmanship according to the intent of these specifications and shall report to the Owner’srepresentative any conditions which will prevent the Designer-Builder from performing the workaccording to requirements. No waiver of responsibility for defective work will be considered unlessnotice has been filed at the time the Designer-Builder firm submitted its proposal.It is the intention of these Specifications to call for furnished work tested and ready for operation.Whenever the word “provide” is used, it shall mean “furnish and install, complete and ready foruse”. Minor details not usually shown or specified, but necessary for the proper and efficientinstallation shall be included in the work, the same as if herein specified or shown.6.0 DESIGN AND BUILD ACTIVITIES6.1 DESIGN PHASE:The activities of the Designer-Builder for the detailed design phase would include but notlimited to the following: