Installation Guide - raytec.ro

More documents

Recommendations

Info

Trouble ShootingEnsure all tests are undertaken by a qualified, trained engineer.Ensure safe working practices are followed at all timesStep 1: Basics• Check polarity of Infra Red Lamp connectionred=+ve, black=-ve• Check telemetry link is in• Check photocell is working• Check power setting pot fully clockwise• Check mains input• Check fuse intactIf OK…Step 2: Lamp TestCheck voltage of lamp o/p approx 14V (8V for pulsed units)Check current of lamp – see instructions for correct current settingTo check lamp current (this must be done while both LED panelsare connected to the PSU) remove +ve LED from both lamp supplycables and connect multimeter set to 10A current in line with thelamp. [One lead of multimeter in common (COM), other lead into10A socket of multimeter; set multimeter to 10A readings]. Refer toPSU Specifications for correct current settings, see pages 6-7.10
Step 3: Set-up Camera, lens and illuminationCheck alignment of lampCheck camera lens – fully open at night & set correctlyCheck model number to Raytec performance specification to ensurerequired distance is achievableStep 4: Call Raytec for further assistanceNote down:• Model and serial number of illuminator• Camera make and model• Lens make and modelIf the Raytec lamp is still not delivering the required performance,please contact us for further assistance.11
Page 5 and 6: Technical Drawings (Not to scale)St
Page 7 and 8: Low Voltage PSU (LVP) Specification
Page 9: Infra-Red and White-LightRM/RL 300/

Installation Guide - raytec.ro

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?