000107 - Agfa HealthCare

Page 10 of 25MED/RLR/000107Document No. 000107, Revision 3.111 September, 2000 Agfa Medical ImagingImpax provides Standard Conformance to the following DICOM V3.0 Management SOP Classes as anSCU.SOP ClassSOP Class UIDDetached Patient Management 1.2.840.10008.3.1.2.1.1Detached Visit Management 1.2.840.10008.3.1.2.2.1Detached Study Management 1.2.840.10008.3.1.2.3.1Detached Results Management 1.2.840.10008.3.1.2.5.1Detached Interpretation Management 1.2.840.10008.3.1.2.6.1Study Component Management 1.2.840.10008.3.1.2.3.2Modality Worklist Information Model – FIND 1.2.840.10008.5.1.4.31Table 3.2 Management SOP classes.SOP ClassDICOM Implicit VR Little Endian 1.2.840.10008.1.2SOP Class UIDTable 3.3 Transfer syntax.3.1.1 Association Establishment Policies3.1.1.1 General3.1.1.2 Number of AssociationsThe maximum number of simultaneous associations accepted by Impax is configurable at run time, based onthe system resources available. By default, the maximum number of associations is set at 32. There is noinherent limit to the number of associations other than limits imposed by the computer operating system.3.1.1.3 Asynchronous NatureImpax allows a single outstanding operation on any association. Therefore, Impax does not supportasynchronous operations window negotiation, other than the default as specified by the DICOM specification.3.1.1.4 Implementation Identifying InformationImpax responds with the following implementation identifying parameters: Implementation Class UID: 1.3.51.0.2.1Implementation Version Name: Impax_NWG_3.0The implementation version name policies are the following: product name “Impax_NWG” followed by theversion of the product, “_3.0”.3.1.1.5 Called/Calling TitlesThe default calling title that Impax will use is “Impax_NWG”. This parameter can be configured beforeapplication startup.A]