Double-Dry-nOn-cooled-Probe - Webshop, Gas Analysis Technology

Unit Operation InstructionDDOP Probe6 FUNCTION DESCRIPTION OF PROBESee layout drawing “SDSP Probe”6.1 UNIT OVERVIEWHeat shieldWeld flangeFilters(Hidden)Sample and BBhoseconnecetionsPic 1 Probe parts overviewProbes Line 1and Line 2Sample hose clamps6.2 PARTSTag number Type FunctionW1 Probe Probe default tag numberDetailed view with subparts can be seen on drawing “DDOP Probe”6.3 FUNCTION DESCRIPTION PROBEThe purpose of the probe is to ensure that the gasses measured are representative for theprocess gas. The sample end of the probe is inserted into the process. The probe is a doubleprobe thus it can be used for continuous measuringThe probe is made of a stainless steel alloy, which has proven efficient for the application.6.4 COMMISSIONING OF PROBEAfter installation as described in section 4.2 and checking of all electrical and mechanicalinstallation, the Probe can be commissioned in conjunction with analysis system asdescribed in “System Manual” The Probe is not requiring any adjustments.· Check all bolts are tightened properly· Check sample hoses and blow back hoses are correct installed as described· Check the white insulating cover is correct installed.6.5 DISMOUNTING PROBETo dismount the probe, follow this procedure:Issue:Procedure:Set GMU in test modePut the system into TEST mode and stop the analysis, asdescribed in “System operation manual”Disconnecting all hosesDisconnect sample lineDismount the probeThe probe can now be dismounted from its flangeDrawing no: 53895-DDOP-450-20 Page 10 of 14