N-ZEDAB60-ANT - Zenec

INSTALLATION GUIDEN-ZEDAB60-ANTDAB ANTENNA CAUTION• The film antenna is exclusively for useinside the vehicle.• Do not install this film antenna at thefollowing locations:- Where it may block driver‘s view.- Where it may obstruct operation ofsafety devices such as airbags.- On movable glass surface.• Be sure to check the installation locationof film antenna before installation. Filmantenna cannot be re-pasted, so pleasecheck the cable grounding mechanismbefore actually pasting the antenna ontothe wind glass.• Thoroughly wipe oil and dirt off from thepasting surface with the included cleaner.• Do not bend or damage the film antenna.ITEMS INCLUDE• Film antennaContact portInstallation overviewFront pillarFilm antennaZE-DAB60Antenna input cablemin.5 cmSPECIFICATIONS• Antenna system: Passive antenna• Frequency range: 170-240 MHz• Connector type: SMA• Cable length: 3 metres• Antenna lead with earth stripe andcontact box• Wipe cleanerContact portCONFIRM THE PLACE• Identify an ideal place for installation.• Ideal place (on the front glass) for filmantenna installation is the one that meetsthe following conditions:- Vertical: the antenna top should be atleast 5 cm away from the car roof foroptimum reception performance.- Horizontal: the antenna should be alignedwith the car frame (A pillar).• Do not install at the following locations:- Where it may block driver‘s view.- Where it may obstruct operation of safetydevices such as airbags.- On movable glass surface.ZENEC by ACR AG ∙ Bohrturmweg 1 ∙ CH-5330 Bad Zurzach ∙ SwitzerlandRev. A

Step 1. Clean the areaStep 4. Apply with pressureStep 7. Peel off the sticker paper• With wipe cleaner provided,clean the surface whereantenna film, amplifier unitand earth sheet is to beplaced.• Ensure that the glasssurface is completely drybefore mounting.• Warm the front windscreenglass if necessary to ensuregood adhesion.min.5 cm• Apply pressurevertically from bottomto top for secureattachment.• Peel off the sticker paperon contact box.• The metal part of thecontact box should bekept clean.• Match the notches ofthe contact box withthe counter pieces onantenna film.• Paste the contact boxwith gentle pressure.Step 2. Remove the protection slip• Gently remove the protection slip horizontally.• Do not touch the sticky surface (adhesive side) of theantenna film.Step 5. Remove the pillar cover• Remove the frontright pillar covergently.• Take care not tointerfere with theairbag safety systemwhen removing thepillar cover.Step 8. Adhere the earth stripe to carbody (metal part)• Peel off the sticker paperon the earth sheet andstick the earth sheet ontothe metal part of thewindscreen pillar.• You don’t need to removeany paint for the earthcontact to work.• Provide sufficient leewayfor the earth sheet.Step 3. Paste the antenna• Gently paste the antennaalong with A pillar at thepre-set area.• Take care not to touch thecontact port.Step 6. Remove the transparent slip• Remove the transparent slipon antenna film gently butdo not touch the contactport (sticky part of antenna).• Do not apply any glasscleaner.Step 9. Connect the antenna to the unit• Route the antenna cabledown the pillar down andacross the inside of thedash, to the DAB receiverlocation.• Take care that wheninstalling the amplifier partof the antenna cablebehind or away from an airbag or its wiring so that itdoes not interfere with thevehicle safety system.