cover RPD15F,25F.qxp - Chamberlain

Correct useThe RPD15F and RPD25F tubular drives are designed for the exclusive purpose of operating shutters and sun-blind systems. Theyserve to open and close these systems and replace the person that is usually operating the installation Therefore, tubular drives mayonly be installed in faultless shutter- or sun-blind systems. Rough-running systems have to be repaired. Replace defective parts. Thisguarantees safe operation and avoids damage during opening or closing.Any other form of usage is deemed to be incorrect. Neither the manufacturer nor the supplier assumes any liability for personal injury, damage toproperty or consequential injury or damage occurring as a result of the use of the control units and / or drives for purposes other than thosementioned above or due to changes made to the equipment affecting the safety of the given system. 1The details stipulated in the OperatingInstructions in respect of the operation and repair of the system require strict observance. Neither the manufacturer nor the supplier assumesany liability for personal injury, damage to property or consequential injury or damage occurring as a result of non-compliant actions.In compliance with standard EN 60 335-2-97:2000, the cable connecting the drives to the mains cable must be laid internally.According to DIN 18073 shuter box lid must always be easily accessible and removable.en-2BATTERY DISPOSALBatteries and rechargeable batteries may not be disposed along with domestic waste, but are obliged tobe returned. After use they can be returned free of charge locally e.g. in trade or at municipal collectingpoints. Batteries and rechargeable batteries are marked with a crossed waste container as well as withthe chemical symbol which describes their toxic element, “Cd” for cadmium, “Hg” for mercury and “Pb”for lead.12VDCPb Cd HgStandByPerformance FeaturesModel Diameter Torque Speed Operating Frequency Current MotorWOOD 3,0m 2 4,2m 2RPD15FRPD25F(mm)4545(Nm)1525(rpm)1515Voltage(V)230230(Hz)5050input(A)0,600,89rating(W)133191(W)1,41,4Max. area (area = length x breath)RPD15F RPD25FPVC7,5m 2 10m 2ALU6,0m 2 8,0m 2AWNING11,5m 2Operatingtime(min)44Limit SwitchRange(U)2525INSTALLATION PROCESS SEQUENCE AND STEPS1. Install drive (installation)2. Wire up and connect drive (motor connection)3. Set limits of shutter (the remote control has already been programmed).PLEASE NOTE: Should the UP / DOWN button function the wrong way round i.e. as DOWN / UP button, wait until step 5 before changing it!4. Insert shutter armouring (slats) and complete installation.5. Change functionality of remote control (reverse direction of movement (UP/DOWN) on the remote control and programme new remote controls).1. INSTALLATIONRough- in or install conduit pipe to the connector box for the electrical connecting line according to local building and electrical codes.THE DRIVE IS PREMOUNTED. THE DESCRIPTION IS FOR CHECKING PURPOSES!ACarton Contents1. Motor (1)2. • Adjuster pin (2)• Drive adapter safety catch (3)• Square pin (4)• Shaft adapter (5)• Wall bracket (6)3. ManualACRX101 - CRX5015315246