4000CL-O V3.0, 400 Clip Fast Access System using ... - DNF Controls

. RECEIVE CUE LIST FUNCTIONThe RECEIVE CUELIST function allows you to receive a list of Cue Points from a PCor from another ST300. Transfer to a PC requires OpSuite 3.0 software, which runs on aWindows-based computer. Contact DNF Controls for more information.1) To Receive Cue Points From Another ST300a) Connect the VTR4 connector on the back of the ST300 from the VTR4connector of the transmitting ST300 using RS422 9-pin cable with TXand RX lines crossed.(A’Turnaround” Cable)b) Press [MENU].c) Scroll the Wheel until “Receive CUE List? YES=Enter, Exit=ESC” isdisplayed.d) Press [ENTER] to start receiving.The Display shows “Waiting to receive” on the first line.e) When the Transmitter is ready, transfer starts automatically.The Display now shows “Receiving cuelist.”f) After the transfer is over the display shows “Done-Success! Press anykey…”g) Press any key. The display shows “Receive cuelist?” message.h) Press [ESC] to exit the MENU mode.2) To Receive Cue Points From the PCa) Connect the VTR4 connector on the back of the ST300 to one of theCOM ports on the PC using RS422 to RS232 adapter.b) Repeat steps a) – h) of “To Receive Cue Points From AnotherST300,” Section 6.b.1).12 4000CL-O, 400 Clip Fast Access System, Odetics Protocol