Digi Master L-718 - Sekonic

Accessories1. LumisphareUse Lumisphare when you wish tomeasure incident light for portraits andthree-dimensional subjects.< Mounting >Match the red dot on the Lumisphareframe to the setting mark on the swivelhead. Gently rotate the sphareclockwise until it clicks securely intoplace. To remove, rotate the spharecounter-clockwise.Point the Lumisphare accurately towardthe camera from the subject position.Swivel head is rotatable 270°horizontally and 90° upward.2. LumidiscUse Lumidisc when you wish tomeasure lighting contrast and lux aswell as the exposure of singledimensionalsubjects.< Mounting >Same as for the Lumisphare.Hold the meter at the subject position andpoint the Lumidisc accurately toward thelight source. When measuring theexposure of two-dimensional subjects,point the Lumidisc toward the camerafrom the subject position.3. Reflected-light filterUse Reflected-light filter when you wishto measure the reflected light(brightness) of subject. Use it tocalculate the relative brightness ratio(illumination contrast of subject) foradjusting lighting balance, or when it isdifficult to take incident lightmeasurement.< Mounting >Same as for the Lumisphare.Point the reflected-light filter accuratelytoward the subject. When you wish tomeasure some part of the subject, doso as close to the subject as possible.4. Viewfinder 5°(sold separately)Use Viewfinder in the same way as thereflected-light filter to measure reflectedlight. With a light acceptance angle of 5°you can make a spot measurement ofdistant subjects.5. Synchro cord(sold separately)Synchro cord connects the meter to theflash unit for measuring flash light inwired measurement mode. Synchro cord,5 meters length, has 3 plugs so that itcan simultaneously synchronize themeter with the flash unit and the camera.The terminal on the meter has a lockingmechanism to ensure a secureconnection. To disconnect the cord,simply pull the ring attachment towardyou to release the locking mechanism.8