Digi Master L-718 - Sekonic

Liquid Crystal Display(1) b.c. mark (battery check) isdisplayed when the meter isswitched on.(2) Digital value of the measuredF-stop or EV is shown (f/1~f/90 or EV(- 1) ~ EV25), whenthe meter is used in T-prioritymode.(3) F-stop value is set in F-prioritymode for ambient lightmeasurement.(4) E.u. (underexposure) or E.o.(overexposure) mark isdisplayed when the measuringrange is exceeded.Any of the following symbols isdisplayed depending on the modeselection.for wireless (cordless)measurement for flash lightfor wired measurement forflash lightfor cine modeIn case of ambient lightmeasurement (excepting cinemode), no symbol mark isindicated.This display comes into operationwhen the multi-measurement key ispressed in both modes of wirelessand wired measurement for flashlight. The number of cumulativeflashes is limited up to 9. If itexceeds 9, the E mark (error) isindicated.Display for film speed movesthrough a range of ISO 3 ~ ISO8000 by pressing either UP orDOWN key while holding the ISOkey depressed.By pressing F/EV key, the indicatedsymbol is converted from F to EV,and vice versa. When the meter isused in the flash mode, only F markis displayed.When the meter is used in T-prioritymode,(1) F-stop number is also displayedin bar-dot symbols at 1/2 F-stopincrements.(2) The measured F-stop valuesare indicated in bar dot symbolby pressing the memory keyafter each measurement. Thenumber of memorized values islimited up to 2.(1) Battery capacity is shown whenthe meter is switched on.(2) Bar symbols indicate thefractions of F-stop or EV value.(1) Digital value of the measuredshutter speed is shown in thisdisplay (30min. ~ 1/8000sec.),when the meter is used inF-priority mode.(2) Shutter speed is set in T-prioritymode;for flash light:1sec. ~ 1/500sec.for ambient light:30min. ~ 1/8000sec.for cine scale:6fps. ~ 128fps.4