H1072en.pdf - Haynes International, Inc.

More documents

Recommendations

Info

$P:\P25065\H-# Literature\H-2082 - Haynes International, Inc.$

15. REGULATORY INFORMATION (continued)U.S. FEDERALREGULATIONSChemicals subject to the reporting requirements of Section 313 or Title IIIof SARA and 40 CFR Part 372: Aluminum (as a fume or dust), cobalt,chromium, copper, manganese, nickel (as a powder or dust).California=s ASafe Drinking Water and Toxic Enforcement Act of 1986"(Proposition 65)STATE REGULATIONSDuring welding, these products may produce cobalt oxide, nickel compounds,and hexavalent chromium compounds which are known to the State ofCalifornia to cause cancer. State of California, Health and Welfare Agency,1600 Ninth Street, Room 450, Sacramento, CA 95914, Telephone (961) 455-6955.16. OTHER INFORMATIONPennsylvania Worker and Community Right to Know: Aluminum, Cobalt,Copper, Chromium, Manganese, Nickel, and Vanadium (fume or dust) aredesignated environmental hazards on the Hazardous Substance List. Title 34,Part XIII, Chapter 323.MSDS STATUSThis MSDS replaces the 4/11/05 revision for welding consumables. Table 1 and Table 2 were revised withthe addition of Haynes 282 TM alloy.Read and understand the manufacturer=s instructions and precautionary labels on the products. SeeAmerican National Standard Institute standard Z49.1 ASAFETY IN WELDING AND CUTTING@ published bythe American Welding Society, PO Box 351040, Miami, FL 33135, and the OSHA publication 2206 (29 CFR1910) available from the U.S. Government Printing Office, Washington DC 20402.The above information has been prepared by Shaw Environmental, Inc., under contract with HaynesInternational and is a compilation of information from various sources believed to be accurate. As theconditions or methods of use are beyond our control, we do not assume any responsibility and expresslydisclaim any liability for any material described herein. Information contained herein is believed to be trueand accurate, but all statements or suggestions are made without warranty, expressed or implied, regardingaccuracy of the information, the hazards connected with the use of the material or the results to be obtainedfrom the use thereof. Compliance with all applicable Federal, State, and local laws and regulations remainthe responsibility of the user.Portions of this document were authored by Teledyne McKay Co. and are used with permission.H-1072-6 Page 6 of 17
Table 1 Bare Wire Welding ProductsMSDS Welding ProductOctober 2005AWS/UNS Normal Composition, Weight PercentALLOY Alloy No. Ni> Co> Cr> Mo W Fe Si Mn> Al> Ti Cu> B Others (V>)HASTELLOY® B alloy N10001 67 2.5*
Page 5: 12. ECOLOGICAL INFORMATIONIn solid
Page 10 and 11: MSDS Welding ProductOctober 2005Tab
Page 12 and 13: Table 4 Exposure Limits for Potenti
Page 14 and 15: MSDS Welding ProductsOctober 2005Ta
Page 16 and 17: Name of Compound,Formula and CAS Nu

H1072en.pdf - Haynes International, Inc.

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?