Product Owner's Manual - Precor

Tighten all mounting screws.1. Start at the base and alternately tighten the eight fasteners thatsecure the upright supports to the base assembly.2. Wrench tighten the six screws that secure the display console tothe upright supports.CAUTION: Be aware of the handrail extensions when you areworking around the front of the unit. It is easy to bump your heador sustain other injuries if you ignore the location of the handrailextensions.Position the hood over the running belt so you can slide it through theupright supports from the rear. Align the hood with its four fasteners. Usethe ³⁄₁₆-inch hex key to wrench tighten the two side fasteners beforewrench tightening the two fasteners that secure the front of the hood.Before using the unit, make sure it is level. If adjustments are needed,adjust one rear foot at a time. Do not raise the unit more than ¾ inch(2 cm) from the floor.1. Ask a capable assistant to lift the rear portion of the treadmill(using proper lifting techniques).2. Loosen the upper lock nut with a crescent wrench and rotate therear feet as needed.Adjustablerear foot3. Retighten the lock nut and lower the treadmill to the floor.Plug the power cord into an appropriate outlet.Important: The treadmill requires a dedicated, grounded circuit. A20-amp circuit is recommended. Refer to Grounding Instructions inthe Product Owner’s Manual.Check the alignment and adjust the running belt. For instructions,refer to Checking the Alignment and Adjusting the Running Belt. Ifyou wish to test the heart rate feature, refer to the owner’s manual.946i/932i Commercial Treadmill Assembly Guide 5