Dinion IP - NWC-0495 - Bosch

Dinion IP | Installation ManualEN | 77IP addressEnter the desired IP address for the camera in this field. The IP address must bevalid for the network.Subnet maskEnter the appropriate subnet mask for the set IP address here.Gateway addressIf you want the unit to establish a connection to a remote location in a differentsubnet, enter the IP address of the gateway here. Otherwise, this field can remainempty (0.0.0.0).HTTP browser portSelect a different HTTP browser port from the list if required. The default HTTPport is 80.Video transmissionIf the unit is used behind a firewall, TCP (Port 80) should be selected as thetransmission protocol. For use in a local network, choose UDP.NoteMulticast operation is only possible with the UDP protocol. The TCPprotocol does not support multicast connections. The MTU value in UDPmode is 1514 bytes.Ethernet link typeIf the camera is connected to the network via a switch, both devices must havethe same preset network connection type. If necessary, ask your networkadministrator what value the associated switch is set to.Choose Auto for an autosensing network connection. If necessary you can set thevalue to 10 or 100 MBit/s for either full or half-duplex mode (FD or HD).NoteMalfunctions can occur (for example image faults) if the network capacityis not sufficient for transmission of the maximum data rate generated bythe camera.Bosch Security Systems | 2006-05 | V2.0