Dinion IP - NWC-0495 - Bosch

Dinion IP | Installation ManualEN | 67Alarm SettingsHere, you can make the settings for the alarm sources and alarm connections.Alarm inYou can configure the possible alarm triggers for the camera.Alarm input 1Select the option On in order to activate the alarm via the correspondingexternal alarm sensor. Otherwise, select Off.Select Active Low if the alarm is to be triggered by closing the contact. SelectActive High if the alarm is to be triggered by opening the contact.NameYou can enter a name for each alarm input, which is then displayed below theicon for the alarm input on the Livepage during configuration.Alarm connectionsYou can select the response of the camera in case of an alarm. In case of an alarm,the camera can automatically establish a connection to a predefined IP address(compatible MPEG-4 compatible hardware receiver or computer with receptionsoftware). You can enter up to ten IP addresses which will be selected in order bythe unit in case of an alarm until a connection is established.Bosch Security Systems | 2006-05 | V2.0