Dinion IP - NWC-0495 - Bosch

More documents

Recommendations

Info

Dinion IP | Installation ManualEN | 23Adjustment procedure Manual-iris Lens1. Unlock the back focus locking button.2. Adjust the lens to the maximum lens opening.3. Turn the back focus adjustment as required.4. Lock the back focus locking button.Adjustment procedure Video-iris Lens1. Unlock the back focus locking button.2. Access the Lens Wizard menu.3. Set Back Focus Now is highlighted in the menu.4. Turn the back focus adjustment as required.5. Lock the back focus locking button.6. Select Set LVL in the menu; the Level bar appears.7. Point the camera at the scene it will be mostly viewing.8. Adjust the level potentiometer located on the lens until the Level bar is inthe central position.9. Exit the menu.NoteThe best performance with video iris lenses is obtained when the peak/average potentiometer of the lens matches the peak/average balanceconfiguration setting.Install IP address submenuTo operate the camera in your network, a network-valid IP address must beassigned. The factory default IP address is 192.168.0.1Function Selection DescriptionIP AddressEnter an IP address for the camera. Use LEFT/RIGHT to change position in the address, use UP/DOWN to select the digit. Use SELECT to exit theaddress edit screen.Subnet Mask Enter the Subnet mask (default 255.255.255.0)GatewayEnter a Gateway address.ExitReturn to the Install menuBosch Security Systems | 2006-05 | V2.0
EN | 24Dinion IP | Installation ManualNoteThe new IP address, subnet mask and gateway address are set after youleave the menu. The camera reboots internally and the new values are setafter a few seconds.DefaultsTo restore all parameters (including IP address) to the factory defaults, press andhold the Up navigation key for at least 10 seconds and then confirm. Allow a fewseconds for the camera to optimize the picture after a mode reset.NoteRestoring the factory defaults may result in the loss of the IP connection.If this occurs, change the IP address of your browser to the factory defaultvalue. Only restore the factory defaults when it is absolutely necessary.Bosch Security Systems | 2006-05 | V2.0
Page 1 and 2: Dinion IP - NWC-0495ENInstallation
Page 3 and 4: Dinion IP | Installation ManualEN |
Page 9 and 10: EN | viiiDinion IP | Installation M
Page 11 and 12: EN | xDinion IP | Installation Manu
Page 15 and 16: EN | 14Dinion IP | Installation Man
Page 23: EN | 22Dinion IP | Installation Man
Page 41: EN | 40Dinion IP | Installation Man
Page 75 and 76:
EN | 74Dinion IP | Installation Man
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99:
Bosch Sicherheitssysteme GmbHLudwig
show all

Dinion IP - NWC-0495 - Bosch

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?