Operating Manual - KLARO GmbH

Operating Manual for SBR small wastewater treatment systems2.2. Hazard warnings1. In order to ensure safety, all persons who come in direct contact with the plant must familiarisethemselves with the content of this documentation.2. It is not permitted to use the system for any purposes other than described by the manufacturer.3. Locally applicable work and safety regulations and laws must always be complied with even ifthese are not explicitly referred to in these operating instructions. The same applies toenvironmental regulations.4. When the operator detects errors or hazards, the manufacturer or the competent maintenancecompany must immediately be informed about these.5. During normal operation of the machine, safety precautions must never be removed or bridged.Safety precautions may only be temporarily bridged or stopped functioning by the maintenancetechnician for cleaning and maintenance purposes.6. When handling chemical substances, direct contact with chemicals must be avoided as far aspossible. Before working with these substances is permitted, the package instructions must beread and observed.7. If the use of personal protective equipment (protective gloves, protective glasses, gloves, earprotection etc.) is mandatory, care must be taken to ensure that this protective equipment isactually used. Defective or damaged protective equipment must immediately be replaced withproperly functioning protective equipment.8. Work on the electrical system may only be carried out by skilled personnel.9. All safety and hazard warnings at the machine must be kept in well readable condition at anytime.10. Hot parts must not come in contact with explosive or easily inflammable chemicals.11. Do not place any containers with liquids onto electrical switch cabinets; spilling the liquid maycause short-circuits.12. The plant must not be operated when under the influence of alcohol (consider possible residualalcohol from the day before!) or medication impairing the ability to perceive and react.13. Before any maintenance and cleaning work, the plant must be disconnected from the mains.14. The plant must, except for maintenance purposes, always be switched on, since otherwisecorrect wastewater treatment cannot be ensured.8KLARO GmbH