Operating Manual - KLARO GmbH

More documents

Recommendations

Info

Operating Manual for SBR small wastewater treatment systems6. Additional functions of the KLplus and KLbasic controls6.1. Underload detection (KLplus)Malfunction Attention: The activation of the fill-level-dependent mode must be carried out by amaintenance technician or an export. Any incorrect calibration of the plant can causethat the plant is permanently run in the saving mode (cycle pause)! In this case, properpurification is not possible!As standard, the KLplus control is equipped with a pressure sensor by means of which the fill level in thefirst chamber can be determined. This function is used for saving energy with low amounts of inflowingwastewater. This function is switched off in the delivery state. During commissioning, the plant is run inthe automatic mode regardless of the amount of inflowing wastewater.22KLARO GmbH
Operating Manual for SBR small wastewater treatment systems6.1.1. Functional principleThe water level is measured by means of thepressure in the feed lift during the feed phase. Ifthe water level in the sludge storage / buffer(chamber 1) exceeds a previously set fill-levelheight (“Fill-level detection setting“), the plant startsa purification cycle. If the fill level is not reached,the plant enters the cycle pause for a period of sixhours. During this cycle pause, the SBR reactor isonly aerated sporadically in order to keep thebacteria alive. If the previously set water level wasnot reached in the first chamber after foursubsequent measurements, the plant pumps, viathe excess sludge lift, water out of the reactor andback into the first chamber. After the water hasbeen pumped back, the plant measures the waterlevel again. With no or little inflowing wastewater,the reactor is thus also fed after a certain period of Figure 9: Drawing air lifter chargingtime. Hence, the normal purification performancecan also be maintained for a longer period of time in times of absence or underload.The number of the purification cycles performed can be queried via the menu item “operating hours“. Indoing so, the actually performed purification cycles are placed in relation to the cycles carried out in theautomatic mode (four cycles a day) and displayed as a percentage (capacity of 25 % to 100 %).6.1.2. CommissioningFall hazardDuring any work on the opened cover of the cesspit, there is a tripping and fallhazard!The open pit must be secured by means of suitable measures.The first chamber (sludge storage / buffer) equipped with the feed lift must be filled with water up to theheight at which a purification cycle is to be activated. This water level depends on the geometry of thecontainer and the connected PE. In the following table, the recommended buffer heights a above theminimum water level are stated for the different constellations.KLARO GmbH 23
Page 1 and 2: Operating Manualfor SBR small waste
Page 3 and 4: Operating Manual for SBR small wast
Page 9: Operating Manual for SBR small wast
Page 42 and 43: 10. Technical dataOperating Manual
Page 60 and 61: L1L2L1 L2 L3L3Operating Manual for
Page 62 and 63: HOperating Manual for SBR small was
Page 72:
KLARO GmbHSpitzwegstraße 6395447 B
show all

Operating Manual - KLARO GmbH

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?