CompuScope SDK Manua.. - Egmont Instruments

Description of Parameters for gage_driver_info_type StructureValues of the constants used below can be found in GAGE_DRV.H or in GAGE_LOW.H file.indexsegmentBoard_typemax_memorymax_available_memorybank_offset_valuemodeenable_aenable_bratemultipliercoupling_acoupling_extgain_again_bgain_exttrigger_depthbase I/O port index of CompuScope, used to transfer data from theCompuScope card. The value is typically read from the configurationfile GAGESCOP.INC. For PCI CompuScope boards, the value is0xffff.absolute address of memory segment, typically read fromGAGESCOP.INC. For PCI CompuScope boards, the value is 0xffff.numeric constant representing the board type as defined in theGAGE_DRV.H file.memory size of CompuScope board (in samples).available memory (in samples) in current mode, i.e. max_memory insingle channel, max_memory / 2 in dual channel.block number where the data for channel B starts.current mode of the board, which can be GAGE_SINGLE_CHAN orGAGE_DUAL_CHAN or GAGE_QUAD_CHAN. Mode is set bygage_capture_mode routine.current enable status of channel A. On board CompuScope memory iseither connected or disconnected to the transceiver by callinggage_input_control routine with either GAGE_INPUT_ENABLE orGAGE_INPUT_DISABLE.current enable status of channel B. On board CompuScope memory iseither connected or disconnected to the transceiver by callinggage_input_control routine with either GAGE_INPUT_ENABLE orGAGE_INPUT_DISABLE.set by gage_capture_mode routine.set by gage_capture_mode routine. The constants are GAGE_HZ,GAGE_KHZ, GAGE_MHZ, GAGE_GHZ and GAGE_EXT_CLK.status of the coupling for channel A, either GAGE_AC or GAGE_DC.status of the coupling for the external trigger. Use GAGE_AC orGAGE_DC with gage_trigger_control_2 routine.status of the gain value for channel A. One of the predefined constants,such as GAGE_PM_5_V, defined in GAGE_DRV.H file should beused with gage_input_control routine to set this parameter:status of the gain value for channel B. One of the predefined constants,such as GAGE_PM_1_V, defined in GAGE_DRV.H file should beused with gage_input_control routine to set this parameter:status of the gain for the external trigger. To set, use eitherGAGE_PM_5_V or GAGE_PM_1_V with gage_trigger_control_2routine.number of points captured after the trigger event set bygage_trigger_control_2 routine.CompuScope SDK Manual Appendix A Page 57