DALI manual - Tridonic

More documents

Recommendations

Info

.cMaintenance and troubleshootingExample: Two DALI circuits with a voltage drop less than 2 VThe DALI circuit is divided into two when a DALI repeater is used. The two circuits are now both below the maximumpermitted DALI voltage drop of 2 V. The voltage drop must be measured in both circuits (at the two DALI powersupplies). Two additional components are required – a DALI PS and a DALI repeater....DALI Manual | 08-2013 | en84 / 93
.cMaintenance and troubleshootingDouble addressing problem at set-upIn rare cases more than one DALI device may have the same short address. If a DALI command is sent to such a shortaddress the devices will react simultaneously. It will not be possible to address just one device; all the devices with thesame short address will always react together. It will not be possible to get the correct response from these devices.What can cause double addressing problems?The problem may occur very rarely as a result of the normal addressing algorithm.DALI lines that have already been addressed are connected to one another.A faulty DALI device is replaced with a device that has already been addressed.After addressing, the number of addressed devices is shown. This number (DALI short addresses) must be the sameas the number of connected devices. If there are fewer addresses than connected devices the DALI circuit must bere-addressed.masterCONFIGURATOR provides a way of identifying any double addressing problems. It shows if a device does notsend back a clear response. Unknown devices or false device information also indicate double addressing or a faultydevice.If double addressing has occurred the DALI circuit must be readdressed (select the option “new installation”). Thisaction deletes all existing addressed and reassigns them....DALI Manual | 08-2013 | en85 / 93
Page 1:
luxCONTROLDALI manual
Page 7 and 8:
.cIntroduction: DALI standardPositi
Page 9 and 10:
.cDALI controllers of comfortDIM pr
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
.cDALI devicesDALI devicesElectroni
Page 17 and 18:
.cDALI devicesElectronic HID contro
Page 20 and 21:
.cMiscellaneousMiscellaneousDALI Re
Page 22 and 23:
.cDALI power supplyFigure: Delay an
Page 24 and 25:
.cDALI group controllers: DALI GC &
Page 26 and 27:
Page 28 and 29:
Page 30 and 31:
Page 32 and 33:
.cDALI scene controllers: DALI-SC &
Page 34 and 35: .cDALI scene controllers: DALI-SC &
Page 36 and 37: .cDALI multi controller: DALI MCFun
Page 38 and 39: .cDALI multi controller: DALI MC10)
Page 40 and 41: .cDALI multi controller: DALI MCExa
Page 42 and 43: .cDALI TOUCHPANEL 02DALI TOUCHPANEL
Page 44 and 45: .cDALI TOUCHPANEL 02Table: Paramete
Page 46 and 47: .cDALI x/e-touchPANEL 02DALI x/e-to
Page 48 and 49: .cDALI x/e-touchPANEL 02Colour oper
Page 50 and 51: .cDALI x/e-touchPANEL 02Wiring diag
Page 52 and 53: .cDALI sequencer module: DALI SQMSe
Page 54 and 55: .cDALI MSensor 02Constant light con
Page 56 and 57: .cDALI MSensor 02Figure: Overview o
Page 58 and 59: .cDesigning a DALI applicationDesig
Page 60 and 61: .cDesigning a DALI applicationCalcu
Page 62 and 63: .cDesigning a DALI applicationFigur
Page 64 and 65: .cDesigning a DALI applicationFigur
Page 66 and 67: .cDesigning a DALI applicationTable
Page 68 and 69: .cDesigning a DALI applicationTable
Page 70 and 71: .cStart-upStart-upThere are various
Page 72 and 73: .cStart-upTable: Parts listPos. Qty
Page 74 and 75: .cStart-upFigure: Up and down switc
Page 76 and 77: .cStart-upSetting up without softwa
Page 78 and 79: .cStart-upSelect “Start Test”
Page 80 and 81: .cStart-up( 1 ) ( 2 ) ( 3 ) ( 4 ) (
Page 82 and 83: .cMaintenance and troubleshootingMa
Page 86 and 87: .cAnnexAnnexTechnical features of a
Page 88 and 89: .cAnnexTable: Important DALI comman
Page 90 and 91: .cAnnexTable: Overview DALI power s
Page 92 and 93: .cAnnexGO TO SCENE XCan be set usin
show all

DALI manual - Tridonic

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?