DALI manual - Tridonic

.cDALI sequencer module: DALI SQMSet number of scenes in the sequencePress UP button to increase number of scenes in the sequence by onePress DOWN button to decrease number of scenen in the sequence by oneHold DOWN button down to save number of scenesI NOTICEBy default 8 scenes are preset. A maximum of 16 scenes can be set.Switch off lightHold DOWN button down to switch off the connected luminairesThe DALI SQM is activated via a floating contact. When the contact is closed the module is active and continuallysends DALI scene calls. The delay time between the scene calls (step time) can be set on a rotary switch on themodule (shortest time 1 second, longest time 30 minutes). A switch on the module allows you to select the scene afterwhich the sequence starts from the beginning again. The brightness values for the different scenes are set with theDALI GC and SC or via the masterCONFIGURATOR.Cross-fade the DALI SQMCross-fading from scene to scene is determined by the fade time of the DALI ballasts. The range is from 0.7 secondsto 90.5 seconds and is set via the masterCONFIGURATOR software. For more information on setting the fade timeplease refer to the operating instructions for the masterCONFIGURATOR (see Reference list).Figure: DALI SQM cross-fadeI NOTICE...If the step time is less than the fade time the next scene will be selected even if the scene has not been completed.DALI Manual | 08-2013 | en52 / 93