DALI manual - Tridonic

.cDALI multi controller: DALI MC10) Stairwell function:close = command X, start run-ontime, run-on time elapsed =command YIf the push-button is pressed, command X is sent and the run-on time starts.Once the run-on time has elapsed, command Y is sent.Table: Macro descriptionMacroMacro 1: Go homeMacro 2: MSensorautomaticMacro 3:Sequential scenerecallMacro 4: DynamicsceneMacro 5:DALI-ResetMacro 6: e-PowerON LevelMacro 7: PCAcompatibilityMacro 8:User-defined DALIcommandsDescriptionDelayed light off (slow fade down)Lighting control for the selected DALI MSensor is activatedThe next scene is called up each time button connected to the input is pressed. At the end ofthe sequence the process starts again from the beginning.Pressing the button calls up a sequence of four scenes. The cross-fade time and dwell timecan be freely defined for each scene.Reset for the defined devices. As an option all the DALI addresses can be deletedSets the Power ON Level of the DALI ballast to the predefined value. DALI devices that donot support this function ignore the commandSets the “PCA compatibility” parameter in PCA EXCEL lp devices of generation xitec I to thepredefined value. DALI devices that do not support this function ignore the commandThis macro executes a COT file that can be created by the user.For an explanation of the commands see Appendix / Important DALI parameters and DALI commands.Default settingThe DALI MC has the following factory default input settings:DALI Manual | 08-2013 | en38 / 93