DALI manual - Tridonic

.cDALI group controllers: DALI GC & GC-AFigure: Programming mode with deletion of addressesI NOTICEIn programming mode the system first searches for available DALI devices in the DALI circuit. The devices areaddressed as follows:In programming mode with deletion all devices will be automatically addressedIn programming mode without deletion only newly detected devices are addressedDuring the search operation all the detected luminaires are faded to maximum. When the search has beencompleted one luminaire (the one selected) will remain at maximum and all the others will be faded to the lowestvalue.Selecting luminairesTo attach a luminaire to a group, the luminaire must be selected first.Choose a button of the momentary switchPress button briefly to select a luminaire→ Selected luminaire is faded to maximum→ All other luminaires are dimmed to minimumPress button again to select another luminaireI NOTICEA single luminaire can contain more than one device. If this is the case all devices in the luminaire must be selectedseparately.The luminaires are selected in the sequence in which they are found. When you come to the last luminaire in thesequence, the next one selected will be the first luminaire in the sequence again. A selected luminaire can now beassigned to a group.Assigning a selected luminaire to a groupIf a luminaire is assigned to a certain group it reacts to fade commands that come from momentary switches of thesame group. The group assigned can be stored in the selected DALI device.Make sure that the right luminaire is selectedChoose a button that is assigned to the right groupDALI Manual | 08-2013 | en27 / 93