User Manual M3000® Automation System / MSC II (Moog Servo ...

7 Networking M3000 ® Modules Ethernet
7.1.2 Networking of More Than 2 Network Stations
A hub or switch is needed for Ethernet networks that have more than 2 stations.
The hub transfers the signals sent from one of the stations to every
other station in the network.
Figure 34: Ethernet Network with more than 2 Network Stations
7.1.3 Ethernet Interface Cables
RJ45 Mating
Connector
8
1
Figure 35: 100BaseT Cable with Crossed Twisted Pair Wires (Crossover Cable)
with 8 Pole RJ45 Mating Connectors, Cable Category 5, Wire Cross Section > 0.22 mm² (24 AWG)
RJ45 Mating
Connector
8
1
Hub/Switch
1
2
3
6
1
2
3
6
Network Station 1
(e.g.: PC)
Network Station 2
(e.g.: MSC II)
Network Station N
(e.g.: MSC II)
• 100BaseT patch or crossover cable with twisted pair
wires for MSC II and MSD Motion Controller
• 10BaseT patch cable with twisted pair wires for MSC I
TD+
TD-
RD+
RD-
TD+
TD-
RD+
RD-
Figure 36: 100BaseT Cable with Non-Crossed Twisted Pair Wires (Patch Cable)
with 8 Pole RJ45 Mating Connectors, Cable Category 5, Wire Cross Section > 0.22 mm² (24 AWG)
For the terminal assignment of the Ethernet front panel connector of the
MSC II control module, see: � Ethernet connector on page 80
Ethernet Network with
more than 2 Network
Stations
100BaseT Cable
with Crossed
Twisted Pair Wires
(Crossover Cable)
100BaseT Cable
with Non-Crossed
Twisted Pair Wires
(Patch Cable)
© Moog GmbH User Manual M3000 ® and MSC II (CA65865-001; Version 1.1, 08/08) 48
TD+
TD-
RD+
RD-
RD+
RD-
TD+
TD-
1
2
3
6
1
2
3
6
RJ45 Mating
Connector
1
8
RJ45 Mating
Connector
1
8