User Manual M3000® Automation System / MSC II (Moog Servo ...

2 Safety Instructions Safety Instructions
2.2.9 Run/Stop/Reset
WARNING If the most recent status in the online mode (MACS
logged in) was 'Run' before the MSC II control module
was switched off or reset, the boot project will always be
started after the MSC II control module is switched back
on or reset.
This will occur regardless of which application program was
previously running.
In other words, the application program that will be started
automatically after the MSC II control module is switched on
or reset might be different from the application program that
was executing immediately prior.
More on this subject: �-"10.7-Run/Stop/Reset Switch" on page 88
2.2.10 Switching Back on or Resetting the MSC II
WARNING If the most recent status in the online mode (MACS
logged in) was 'Run' before the MSC II control module
was switched off or reset, the boot project will always be
started after the MSC II control module is switched back
on or reset.
This will occur regardless of which application program was
previously running.
In other words, the application program that will be started
automatically after the MSC II control module is switched on
or reset might be different from the application program that
was executing immediately prior.
More on this subject:
�-"10.8.1-Behavior at Switching on and Switching off" on page 89
2.2.11 'Outputs Enabled' Output of the MSC II
WARNING If there is a defect in an output stage, the 'Outputs Enabled'
signal will not necessarily shut down all of the
outputs securely.
More on this subject:
�-"10.17.2-'Outputs Enabled' Output (LED «OutEN»)" on page 111
Safety Instructions:
Run/Stop/Reset
Safety Instructions:
Switching Back on or
Resetting the MSC II
Safety Instructions:
'Outputs Enabled' Output
of the MSC II
© Moog GmbH User Manual M3000 ® and MSC II (CA65865-001; Version 1.1, 08/08) 12