User Manual M3000® Automation System / MSC II (Moog Servo ...
User Manual M3000® Automation System / MSC II (Moog Servo ...
User Manual M3000® Automation System / MSC II (Moog Servo ...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
1 General Information Trademarks<br />
If the system does not comply with the requirements of DIN EN 61000-6-1<br />
and DIN EN 61000-6-3, despite the additional measures, M3000 ® modules<br />
must not be used in residential, commercial and light-industrial environments.<br />
EMC conformity may be presumed only under the following conditions:<br />
• Sufficient shielding<br />
• Mounting of the DIN rail module onto a DIN top-hat rail that is attached to<br />
an electrically conductive, grounded mounting plate<br />
� figure-17 on page 31<br />
<strong>MSC</strong> <strong>II</strong> and extension modules must be powered from a power supply with<br />
SELV (Safety Extra-Low Voltage) according to DIN EN 60950-1. Therefore<br />
the EU low voltage directive is not relevant for the M3000 ® automation system<br />
because the specified voltage levels lie below the limits.<br />
1.8 Trademarks<br />
<strong>Moog</strong> and <strong>Moog</strong> Authentic Repair are registered trademarks of <strong>Moog</strong> Inc.<br />
and its subsidiaries.<br />
M3000 ® is a trademark of <strong>Moog</strong> GmbH that is registered in the EU.<br />
All product and company names mentioned in this manual might be protected<br />
trademarks or brands of the relevant manufacturer.<br />
The absence of the symbols ® or does not indicate that the name is<br />
free from trademark protection.<br />
1.9 Software Copyrights<br />
The software that is installed on M3000 ® products at the time of delivery is<br />
the property of the manufacturer. At the time of delivery, every piece of installed<br />
software is covered by copyright protection. It may be reproduced only<br />
with the approval of the manufacturer or in accordance with the license<br />
agreements.<br />
Trademarks<br />
Software Copyrights<br />
© <strong>Moog</strong> GmbH <strong>User</strong> <strong>Manual</strong> M3000 ® and <strong>MSC</strong> <strong>II</strong> (CA65865-001; Version 1.1, 08/08) 5