User Manual M3000® Automation System / MSC II (Moog Servo ...

10 MSC II (Moog Servo Controller) Profibus DP Interface
10.11 Profibus DP Interface
The MSC II can optionally be equipped with a Profibus DP Slave interface.
X8
F-Bus
Figure 60: Profibus DP Interface of the MSC II
The configuration of the Profibus interface is defined in the application program.
Information about Profibus:
�-"7.3-Profibus" on page 50
Information about the Profibus interface cable:
�-"7.3.4-Profibus Interface Cable" on page 52
10.11.1 Profibus Termination
At the beginning and the end of any Profibus network, termination resistors
must be connected to guarantee specified signal levels. These termination
resistors are integrated in most common connectors.
10.11.2 Shielding
When connecting the stations, always use shielded cables to ensure high interference
immunity of the system against electromagnetic emissions. The
shield should be grounded on both sides where possible.
10.11.3 Profibus Slave Address
The slave station address of the Profibus interface of the MSC II can be set in
the application program.
10.11.4 Profibus Baud Rate
MSC II
Profibus-
Controller
The Profibus baud rate is defined by the Profibus master station. The MSC II
Profibus slave interface is able to detect the baud rate and synchronize to it.
Profibus DP
Interface of the
MSC II
© Moog GmbH User Manual M3000 ® and MSC II (CA65865-001; Version 1.1, 08/08) 100
CPU