SP88/SP98 Spectrophotometer Operating Manual ... - X-Rite

6.4 Tagging and Storing Operation (with optional BCR)☛ Tags are entered by scanning. If you intend to use the optional Bar Code Reader (BCR), wesuggest that you read Section 9 before continuing with this tagging operation.Tags are used as a method to label stored measurement samples foridentification. The sample data can then be printed or uploaded toX-Rite’s QA-Master ® with tags applied.Individual measurements can have from 1 to 6 tags attached. There arethree tag options to select from once a tag is scanned.Tag All - This option will only appear on the instruments display whenno measurement data is stored in the instrument. Any measurement thatis taken after ‘‘all’’ is selected will have the scanned tag attached.Tag Group - This option will only appear on the instruments displaywhen a new group is selected that has no stored measurements. Anymeasurement taken in that group after ‘‘group’’ is selected will have thescanned tag attached. The first tag that is scanned under group will alsobe used as the group name on the instrument.Tag Next - This option will store the scanned tag with the next samplethat is measured.When the stored measurement data from the instrument is uploaded toX-Rite’s QA-Master software program, all tags that were attached willalso transfer.To tag and store a measurement:1) Press [store] key #4 at the ‘‘MENUPAGE 1’’ level to enter storagefunction.menupg2MENU PAGE 1passnorm fail storeKey#1 Key#2 Key#3 Key#4Press6-10➩