Manual - LP2824 - logmaster

More documents

Recommendations

Info

Replacing the PlatenRemovalMOVIEOpen the printer and remove any media.1. Using a pointed stylus (such astweezers, small slot-head screwdriver,or razor-knife), unhook the tabs on theright and left sides. Then rotate themforward.2. Lift the platen out of the printer’sbottom frame.AssemblyMake sure the right bearing is on the shaftof the platen.1. Align the platen with the gear to theleft and lower it into the printer’sbottom frame.2. Rotate the tabs back and snap theminto place.28 980481-001A
Replacing the Print HeadIn the event you need to replace the print head, read the procedure andreview the removal and installation steps before actually replacing the printhead.MOVIEPrepare your work area by protecting against static discharge. Your workarea must be static-safe and include a properly grounded conductivecushioned mat to hold the printer and a conductive wrist strap for yourself.NOTE: Turn the printer power off and unplug the power cord beforereplacing the print head.980481-001A 29
Page 1 and 2: Zebra ®LP 2824Desktop PrinterUser
Page 3 and 4: Proprietary StatementThis manual co
Page 5 and 6: ContentsIntroductionHello!. . . . .
Page 7 and 8: 980481-001A vii
Page 9 and 10: IntroductionThis section describes
Page 11 and 12: Inspecting the PrinterLook at the o
Page 13 and 14: Closing the printerLower the top co
Page 15 and 16: Getting StartedThis section describ
Page 17 and 18: Loading Roll MediaWhen you load med
Page 19 and 20: Using the GuidesThe guides direct t
Page 21 and 22: Media Length SensingMOVIEBefore you
Page 23 and 24: USB Interface RequirementsUniversal
Page 25 and 26: Serial CommunicationsSerial communi
Page 27 and 28: Operation & OptionsThis section hel
Page 29 and 30: Printing in Peel-ModeThe optional d
Page 31 and 32: Using the Cutter OptionPrinters tha
Page 33 and 34: MaintenanceCleaningWhen you clean t
Page 35: Platen ConsiderationsThe standard p
Page 39 and 40: Replacing the LP Print Head (Contin
Page 41 and 42: TroubleshootingWhat the Status Ligh
Page 43 and 44: Media HandlingProblemPrinting conti
Page 45 and 46: The printing does not start at the
Page 47 and 48: Resetting the Factory Default Value
Page 49 and 50: AppendixInterfacesUniversal Serial
Page 51 and 52: ZebraNet® PrintServer II for Ether
Page 53 and 54: Serial (RJ-11) Alternative Connecto

Manual - LP2824 - logmaster

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?