Manual - LP2824 - logmaster

Using the Cutter OptionPrinters that have a bezel with a motorized blade can dispense one or moreforms that are then automatically cut from the media supply. This optioncuts through continuous paper from rolls and liner between labels. Keepthe cutter dry. Never use any solutions or solvents to clean the blade.Use the f command to set the cut position and the C command to cutimmediately outside a form.If the blade cuts through labels, adhesivecan jam the cutter.1. Turn OFF (O) printer power andunplug the power and interface cablesbefore clearing the cutter.2. After removing debris, plug in thepower and interface cables, turn onthe printer, then test for normaloperation.980481-001A 23