Manual - LP2824 - logmaster

Operation & OptionsThis section helps you get the most from your printer.You must use programming to control many of the printer’s functions. Afew examples:■■The Q command (set form length) controls label length.The O command (hardware options) has a parameter "D" that changesthe printing mode to direct thermal.For detailed information about creating labels using page descriptionprogramming language, refer to the programming guide.To improve print quality, changing both print speed and density may berequired to achieve the desired results. Your application’s printer driverprovides control of the speed and heat (density).Thermal PrintingThe print head becomes hot while printing. To protect from damaging theprint head and risk of personal injury, avoid touching the print head. Useonly the cleaning pen to perform maintenance.The discharge of electrostatic energy that accumulates on the surface of thehuman body or other surfaces can damage or destroy the print head orelectronic components used in this device. You must observe static-safeprocedures when working with the print head or the electronic componentsunder the top cover.You must use the correct media for the type of printing you require. Youmust use direct thermal media.980481-001A 19