Manual - LP2824 - logmaster

Serial CommunicationsSerial communications between the printer and the host computer can be setby the Y command.Y CommandUse the serial port setup (Y) command to change the communicationssettings on the printer.1. With the host computer set at the same communications settings as theprinter, send the Y command to change the printer to the desiredsettings.2. Change the host computer settings to match the new printer settings.Refer to the programming guide for more information about this command.Default the Serial ParametersThe default communications parameters on the printer are 9600 baud, noparity, 8 data bits, 1 stop bit. Many utilities, downloaders and programs usethese settings.980481-001A 17