Manual - LP2824 - logmaster

More documents

Recommendations

Info

Communicating with the PrinterUniversal Serial Bus (USB) CommunicationsThe printer is a terminal device when using a universal serial bus interface.You can refer to the Universal Serial Bus Specification for details regardingthis interface.Parallel CommunicationsWhen using the parallel port, typically there is no setup is required once thecable is plugged in. If you should encounter any problems, consult theuser’s guide that came with your computer.Internal ZebraNet® PrintServer II CommunicationsYou can refer to the ZebraNet® PrintServer II for Ethernet NetworksInstallation and Operation Guide for details regarding this interface.16 980481-001A
Serial CommunicationsSerial communications between the printer and the host computer can be setby the Y command.Y CommandUse the serial port setup (Y) command to change the communicationssettings on the printer.1. With the host computer set at the same communications settings as theprinter, send the Y command to change the printer to the desiredsettings.2. Change the host computer settings to match the new printer settings.Refer to the programming guide for more information about this command.Default the Serial ParametersThe default communications parameters on the printer are 9600 baud, noparity, 8 data bits, 1 stop bit. Many utilities, downloaders and programs usethese settings.980481-001A 17
Page 1 and 2: Zebra ®LP 2824Desktop PrinterUser
Page 3 and 4: Proprietary StatementThis manual co
Page 5 and 6: ContentsIntroductionHello!. . . . .
Page 7 and 8: 980481-001A vii
Page 9 and 10: IntroductionThis section describes
Page 11 and 12: Inspecting the PrinterLook at the o
Page 13 and 14: Closing the printerLower the top co
Page 15 and 16: Getting StartedThis section describ
Page 17 and 18: Loading Roll MediaWhen you load med
Page 19 and 20: Using the GuidesThe guides direct t
Page 21 and 22: Media Length SensingMOVIEBefore you
Page 23: USB Interface RequirementsUniversal
Page 27 and 28: Operation & OptionsThis section hel
Page 29 and 30: Printing in Peel-ModeThe optional d
Page 31 and 32: Using the Cutter OptionPrinters tha
Page 33 and 34: MaintenanceCleaningWhen you clean t
Page 35 and 36: Platen ConsiderationsThe standard p
Page 37 and 38: Replacing the Print HeadIn the even
Page 39 and 40: Replacing the LP Print Head (Contin
Page 41 and 42: TroubleshootingWhat the Status Ligh
Page 43 and 44: Media HandlingProblemPrinting conti
Page 45 and 46: The printing does not start at the
Page 47 and 48: Resetting the Factory Default Value
Page 49 and 50: AppendixInterfacesUniversal Serial
Page 51 and 52: ZebraNet® PrintServer II for Ether
Page 53 and 54: Serial (RJ-11) Alternative Connecto

Manual - LP2824 - logmaster

Create successful ePaper yourself

Delete template?

Save as template?