Manual - LP2824 - logmaster

Hooking Up the Printer and ComputerYour printer will have one of these combinations of interfaces:■■■ParallelUniversal Serial Bus (USB) and DB-9 serialEthernet and RJ-11 serialEach specific interface option—USB, parallel, ethernet, serial—is discussedindividually.You must supply the required interface cable for your application.CAUTIONS:Keep the power switch in the OFF position whenattaching the interface cable.Interface Cable RequirementsThe power supply barrel connector must be insertedinto the power supply receptacle on the back of theprinter before connecting or disconnecting the communicationscables.This printer complies with FCC “Rules and Regulations,”Part 15, for Class B Equipment, using fullyshielded six-foot data cables. Use of longer cables orunshielded cables may increase radiated emissionsabove the Class B limits.Data cables must be of fully shielded construction and fitted with metal ormetalized connector shells. Shielded cables and connectors are required toprevent radiation and reception of electrical noise.To minimize electrical noise pickup in the cable:Keep data cables as short as possible (6’ [1.83 m] recommended).Do not tightly bundle the data cables with power cords.Do not tie the data cables to power wire conduits.14 980481-001A